Experimental investigation on unstable flow in multi-stage centrifugal blower with inlet guide vane

被引:5
|
作者
Hiradate, Kiyotaka [1 ]
Sakamoto, Kiyohide [1 ]
Shinkawa, Yasushi [2 ]
Joukou, Satoshi [2 ]
Uchiyama, Takeshi [2 ]
机构
[1] Hitachi Ltd, Res & Dev Grp, Ctr Technol Innovat Mech Engn, 832-2 Horiguchi, Hitachinaka, Ibaraki 3120034, Japan
[2] Hitachi Ltd, Ind Prod Co, Machinery Syst Div, 603 Kandatsu, Tsuchiura, Ibaraki 3000013, Japan
来源
关键词
Centrifugal blower; Multi-stage; Inlet guide vane; Rotating stall; Surge;
D O I
10.1299/jfst.2016jfst0009
中图分类号
O3 [力学];
学科分类号
08 ; 0801 ;
摘要
This study experimentally investigates the unstable flow in a five-stage centrifugal blower with inlet guide vanes (IGVs) upstream of the first stage. Performance characteristics of the blower were obtained under three IGVs opening conditions. Measurements of the unsteady pressure were performed using six high-response pressure transducers. To distinguish rotating stall from surge, three of these transducers were located thirty degrees apart in the circumferential direction at the vaneless space upstream of the diffuser vane. Three types of pressure fluctuation in the low flowrate region were confirmed. The first one occurred in the positive slope region of the total-system head curve with the largest amplitude and the lowest frequency under the full opening condition of IGVs. The second one was the spike-like fluctuation propagating in the circumferential direction in the vaneless space. The last one appeared under the partial opening condition of IGVs with smaller amplitude and higher frequency than those of the first one. It was confirmed that this pressure fluctuation oscillated at the same phase in the vaneless space and occurred even in the steeply negative slope region of the total-system head curve under the minimum opening condition of IGVs. It was considered that the first one was deep surge and the second one was rotating stall. The last one was considered to be mild surge. Under the minimum opening condition of IGVs, the slope of the head curve of the first stage becomes steeply negative by prewhirl. This negative slope stabilizes the total system of the blower. By contrast, the slope of the head curve of the other stages becomes positive in the low flowrate region. This positive slope destabilizes the total system of the blower. Therefore, even if the total-system head curve keeps a steeply negative slope, the system operating point is considered to oscillate slightly, corresponding to mild surge situation, due to these stability balances.
引用
收藏
页数:13
相关论文
共 50 条
  • [31] Flow analysis in a return channel of a multi-stage centrifugal pump
    Junghyun Lee
    Mohammad Moshfeghi
    Nahmkeon Hur
    In Sik Yoon
    Journal of Mechanical Science and Technology, 2016, 30 : 3993 - 4000
  • [32] Experimental study on noise control of a centrifugal blower using tooth shape vane
    Lu, X.
    Nongye Jixie Xuebao/Transactions of the Chinese Society of Agricultural Machinery, 2001, 32 (05): : 86 - 88
  • [33] Numerical Investigation of Transient Flow Characteristics in a Centrifugal Compressor Stage with Variable Inlet Guide Vanes at Low Mass Flow Rates
    Li, Shuai
    Liu, Yan
    Omidi, Mohammad
    Zhang, Chuang
    Li, Hongkun
    ENERGIES, 2021, 14 (23)
  • [34] Experimental Reduction of Transonic Fan Forced Response by Inlet Guide Vane Flow Control
    Bailie, S. Todd
    Ng, Wing F.
    Copenhaver, William W.
    JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME, 2010, 132 (02):
  • [35] Numerical investigation of influence of inlet guide vanes on unsteady flow in a centrifugal pump
    Wang Yuchuan
    Tan Lei
    Zhu Baoshan
    Cao ShuLiang
    Wang Binbin
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE, 2015, 229 (18) : 3405 - 3416
  • [36] EXPERIMENTAL INVESTIGATION OF SYNCHRONOUS FLOW INDUCED BLADE VIBRATIONS ON A RADIAL TURBINE - PART 1: NOMINAL INLET GUIDE VANE
    Schafferus, Markus
    Sasakaros, Marios
    Wirsum, Manfred
    Zobel, Arthur
    Vogt, Damian
    Nakos, Alex
    Beirow, Bernd
    PROCEEDINGS OF ASME TURBO EXPO 2023: TURBOMACHINERY TECHNICAL CONFERENCE AND EXPOSITION, GT2023, VOL 11A, 2023,
  • [37] The influence of guide vane setting on the initiation of Rotating Stall in multi-stage axial compressors
    Walbaum, M
    Riess, W
    THERMAL TURBOMACHINERY: TURBOCOMPRESSORS IN INDUSTRIAL USE, 1998, 1425 : 177 - 188
  • [38] EXPERIMENTAL AND NUMERICAL INVESTIGATION OF THE FLOW FIELD IN THE RADIAL INLET OF A CENTRIFUGAL COMPRESSOR
    Han, Fenghui
    Qi, Datong
    Tan, Jiajian
    Wang, Li
    Mao, Yijun
    PROCEEDINGS OF THE ASME TURBO EXPO 2012, VOL 8, PTS A-C, 2012, : 831 - +
  • [39] Numerical analyses and development of an industrial centrifugal compressor inlet guide vane system
    Coppinger, ML
    Swain, ED
    CFD IN FLUID MACHINERY DESIGN, 1998, 1998 (13): : 1 - 13
  • [40] Performance prediction and optimization of an industrial centrifugal compressor inlet guide vane system
    Coppinger, M
    Swain, E
    THIRD EUROPEAN CONFERENCE ON TURBOMACHINERY - VOLS A AND B: FLUID DYNAMICS AND THERMODYNAMICS, 1999, 1999 (1A-1B): : 839 - 851