A CURRENT-SOURCED DC-DC CONVERTER DERIVED VIA THE DUALITY PRINCIPLE FROM THE HALF-BRIDGE CONVERTER

被引：153

作者：

WOLFS, PJ

机构：

[1] Department of Electrical Engineering, University of Central Queensland

来源：

IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS | 1993年 / 40卷 / 01期

关键词：

D O I：

10.1109/41.184830

中图分类号：

TP [自动化技术、计算机技术];

学科分类号：

0812 ;

摘要：

A new current-sourced switch-mode power supply topology is developed by the application of a duality principle to a voltage-sourced half-bridge converter. The new converter has boost converter characteristics and is suited to low-voltage high-current input applications. The new converter is shown to compare favorably with the center-tapped transformer converter that has found wide application at low voltages. Two optional enhancements-nondissipative snubber networks and inductor clamping windings-are also examined. Some results obtained with a low-power prototype are also presented.

引用

页码：139 / 144

页数：6

共 13 条

[1]

Desoer C.A., Kuh E.S., Basic Circuit Theory, pp. 455-456, (1969)

[2]

Balabanian N., Bickart T.A., Electrical Network Theory, pp. 118-122, (1969)

[3]

Cuk S., General topological properties of switching structures, IEEE PESC Conf Rec, pp. 109-130, (1979)

[4]

Foch H., Marty P., Roux J., Use of duality rules in the conception of transistorized converters, Proc. APEC Conf. Rec 1980, pp. 4B.3.1-4B.3.11, (1980)

[5]

Severns R.P., Bloom G.E., Modem DC to DC Switchmode Power Converter Circuits, Ch. 9., (1985)

[6]

Freeland S., Techniques for the practical application of duality to power circuits, Proc. IEEE PESC Conf. Rec, pp. 114-122, (1989)

[7]

Block A., On method for the construction of networks dual to non-planar networks, Proc. Physical Soc., 58, pp. 677-694, (1946)

[8]

Redl R., Sokal N.O., Push-pull current-fed multiple-output regulated wide-input-range dc/dc power converter with only one inductor and with 0 to 100% switch duty ratio: Operation at duty ratio below 50%, Proc. IEEE PESC Conf Rec, pp. 204-212, (1981)

[9]

Thottuvelil V.J., Wilson T.G., Owen H.A., Analysis and design of a push-pull current fed converter topology, Proc. IEEE PESC Conf. Rec, pp. 192-203, (1981)

[10]

Redl R., Sokal N.O., Push-pull current-fed multiple-output regulated wide-input-range dc/dc power converter with only one inductor and with 0 to 100% switch duty ratio, Proc. IEEE PESC Conf. Rec, pp. 341-345, (1980)

← 1 2 →