Thermo-economic Optimization of Gas Turbine Power Plant with Details in Intercooler

In this paper a gas turbine power plant with intercooler is modeled and optimized. The intercooler is modeled in details using the e-NTU method. Air compressor pressure ratio, compressor isentropic efficiency, gas turbine isentropic efficiency, turbine inlet temperature, cooling capacity of the absorption chiller, recuperator effectiveness as well as eight parameters for configuration of the intercooler are selected as design variables. Multi-objective genetic algorithm is applied to optimize the total cost rate and total cycle efficiency simultaneously. Two plants including an intercooler and with/without air preheater are studied separately. It is observed that the air compressor pressure ratio in the HP compressor is higher than the LP compressor in both cases and its differences are higher for a plant without an air preheater. Actually the air compressor pressure ratio is found to be about 8.5% lower than the ideal value and 9.5% higher than the ideal value in the LP compressor and HP compressor, respectively, in the case with an air preheater. Moreover, a correlation for intercooler pressure drop in terms of its effectiveness was derived in the optimum situation for each case. (C) 2013 Wiley Periodicals, Inc.