Forces were measured at the articular surface of the temporomandibular joint (TMJ) condyle in two stump-tail monkeys (Macaca arctoides) during chewing, incisal biting, and drinking and also during aggressive behaviors. Force was measured with a thin piezoelectric foil transducer, which was cemented over the anterior and superior surfaces of the condyle. Wires from the upper and lower surfaces of the foil were insulated between two layers of Tefion tape and run subcutaneously to a telemetry unit, which was implanted in the upper back. Force applied across the foil by the condyle was detected by the telemetry unit and transmitted to an FM radio receiver outside the animal. The FM signals were received and demodulated, and a signal proportional to the force applied between the condyle and the TMJ fossa was displayed on a chart recorder. Data were collected over an 8-day period. The animals were not constrained. The TMJ was found to be load bearing. The greatest force of 39.0 lb (17.7 kg) was measured during feisty vocal aggression. Forces ranged as high as 34.5 lb (15.7 kg) during chewing and 28.5 lb (13.0 kg) during incisal biting. Forces were greater on the working (food) side than on the nonworking (balancing) side by average ratios of 1.4 to 2.6. A large unilateral interference at the most distal molar greatly disturbed chewing. It reduced TMJ forces by 50% or more, and the monkey refused to chew on the side opposite the interference. © 1990 Mosby-Year Book, Inc.
