COLD-ROLLING OF FOIL

被引：112

作者：

FLECK, NA

JOHNSON, KL

MEAR, ME

ZHANG, LC

机构：

[1] Department of Engineering, University of Cambridge

来源：

PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE | 1992年 / 206卷 / 02期

关键词：

D O I：

10.1243/PIME_PROC_1992_206_064_02

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

A theory of cold rolling of thin gauge strip is presented which, within the idealizations of homogeneous deformation and a constant coefficient of Coulomb friction, rigorously models the elastic deformation of the rolls and the frictional traction at the interface. In contrast with classical theories (3) it is shown that,for gauges less than a critical value, plastic reduction takes place in two zones, at entry and exit, which are separated by a neutral zone in which the rolls are compressed flat and there is no slip between the rolls and the strip. Roll load and torque are governed by five independent non-dimensional parameters which express the influence of gauge, reduction,friction and front and back tensions. Values of load and torque have been computed (for zero front and back tensions) for a wide range of thickness, reduction and friction and have been found to collapse approximately on to a single master curve.

引用

页码：119 / 131

页数：13

共 16 条

[1]

von Karmann T., Beitrag zür theoric des Walzvorganges. Z, angeur. Math. Mech., 5, (1925)

[2]

Orowan E., Graphical calculation of roll pressure with the assumptions of homogeneous compression and slipping friction, Proc. Instn Mech. Engrs, 150, (1943)

[3]

Bland D.R., Ford H., The calculation of roll force and torque in cold strip rolling with tensions, Proc. Instn Mech. Engrs, 159, (1948)

[4]

Hitchcock J.H., Roll neck bearings, (1935)

[5]

Johnson K.L., Bentall R.H., The onset of yield in the cold rolling of thin strip, J. Mech. Phys. Solids, 17, (1969)

[6]

Fleck N.A., Johnson K.L., Towards a new theory of cold rolling thin foil, Int. J. Mech. Sci., 29, 7, pp. 507-524, (1987)

[7]

Grimble M.J., Solution of the nonlinear functional equations representing the roll gap relationships in a cold mill, J. Optimization Theor. Applic., 26, 3, (1978)

[8]

Grimble M.J., Fuller M.A., Bryant G.F., A non-circular arc roll force model for cold rolling, Int. J. Num. Meth. Engng, 12, (1978)

[9]

Jortner D., Osterle J.F., Zorowski C.F., An analysis of cold strip rolling, Int. J. Mech. Sci., 2, pp. 179-194, (1960)

[10]

Hill R., The mathematical theory of plasticity, (1950)

← 1 2 →