A study of a kinetic rate equation model for simulations of MBE crystal growth: A comparison with Monte Carlo simulations

被引:2
|
作者
Papajova, D
Nemeth, S
Hagston, WE
Sitter, H
Vesely, M
机构
[1] UNIV HULL, DEPT APPL PHYS, KINGSTON HULL HU6 7RX, N HUMBERSIDE, ENGLAND
[2] JOHANNES KEPLER UNIV, INST EXPTL PHYS, FESTKORPERPHYS ABT, A-4040 LINZ, AUSTRIA
关键词
computer simulation; molecular beam epitaxy; surface morphology;
D O I
10.1016/0040-6090(95)06631-4
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
We present the simulations of molecular beam epitaxy (MBE) growth using a rate equation (RE) model and its comparison with Monte-Carlo (MC) simulations. The advantage of the RE model is the higher speed of calculations, so a much shorter time is required for obtaining results, The RE model is described by a set of differential equations that calculate at each time interval the change of the N-kj numbers of atoms and islands of each k size in each jth layer. This change is due to kinetic processes occurring on the surface during the growth. In the original model (R. Kariotis and H.G. Lagally, Surf Sci., 216 (1989) 557) the probabilities of these processes were described by parameters (input parameters for equations) and the simulations of MBE growth were realized by an appropriate choice of them. To make this model applicable to real simulations, we have included the substrate-temperature dependence of all input parameters using an Arrhenius form, This form is used in MC simulations to calculate a migration of atoms on the surface with substrate-temperature dependence. Since the RE model is described by a set of differential equations it was important to first find the allowed temperature range for simulations. This range includes the substrate temperature for the 3D growth mode (low temperatures) and also for the 2D growth mode (epitaxial temperatures). Using an Arrhenius form for temperature dependence of the parameters in the RE model we were able to compare the obtained results with MC calculations. We have made MC simulations (S, Nemeth, R. Harman and M. Vesely;, Correlation between the stochastic simulation of molecular beam epitaxy growth and experiment, 9th Int. Conf. of Thin Films, 6-10 September, 1993, Vienna, Austria) using the same input parameters (T = 775 K, E(n) = 0.3 eV, E(s) = 1.45 eV). Since the RE model is strongly substrate-size dependent (D. Papajova, W.E. Hagston and P. Harrison, Appl. Phys. A, 59 (1994) 215-222; D. Papajova, S. Nemeth, W.E Hagston, H. Sitter and M. Vesely, J.Appl. Phys. A, submitted) we have found very good agreement in 2D growth for smaller substrate sizes S (in the RE model) only, when this dependence does not influence the results.
引用
收藏
页码:47 / 50
页数:4
相关论文
共 50 条
  • [31] Kinetic Monte Carlo simulations for AlN and AlGaN epitaxial growth on AlN
    Miller, Wolfram
    Schulz, Tobias
    Lymperakis, Liverios
    Klump, Andrew
    Albrecht, Martin
    JOURNAL OF CRYSTAL GROWTH, 2023, 607
  • [32] Kinetic Monte Carlo simulations of amorphous thin-film growth
    Elsholz, F.
    Schoell, E.
    Rosenfeld, A.
    PHYSICA STATUS SOLIDI B-BASIC SOLID STATE PHYSICS, 2007, 244 (10): : 3639 - 3646
  • [33] Kinetic Monte Carlo simulations of FeCu alloys
    Domain, C
    Becquart, CS
    van Duysen, JC
    MICROSTRUCTURAL PROCESSES IN IRRADIATED MATERIALS, 1999, 540 : 643 - 648
  • [34] The Kinetic Monte Carlo Simulations of Proton Conductivity
    Tomasz, Maslowski
    6TH WARSAW SCHOOL OF STATISTICAL PHYSICS, 2017, : 111 - 111
  • [35] Kinetic Monte Carlo simulations of FeCu alloys
    Domain, C
    Becquart, CS
    Van Duysen, JC
    MULTISCALE MODELLING OF MATERIALS, 1999, 538 : 217 - 222
  • [36] Kinetic Monte Carlo simulations of proton conductivity
    Maslowski, T.
    Drzewinski, A.
    Ulner, J.
    Wojtkiewicz, J.
    Zdanowska-Fraczek, M.
    Nordlund, K.
    Kuronen, A.
    PHYSICAL REVIEW E, 2014, 90 (01):
  • [37] Monte Carlo simulations of film growth
    Landau, DP
    Pal, S
    Shim, Y
    COMPUTER PHYSICS COMMUNICATIONS, 1999, 121 : 341 - 346
  • [38] Monte Carlo simulations of film growth
    Landau, D.P.
    Pal, S.
    Shim, Y.
    Computer Physics Communications, 1999, 121 : 341 - 346
  • [39] Monte Carlo simulations of film growth
    Ozawa, S
    Sasajima, Y
    Heermann, DW
    THIN SOLID FILMS, 1996, 272 (02) : 172 - 183
  • [40] MONTE-CARLO SIMULATIONS OF CRYSTAL-SURFACES AND CRYSTAL-GROWTH
    BENNEMA, P
    JOURNAL OF METALS, 1980, 32 (08): : 43 - 43