GENERAL CONSEQUENCES OF THE PACKING PHASE IN INJECTION-MOLDING

被引：25
作者：
GREENER, J
机构：
来源：
POLYMER ENGINEERING AND SCIENCE | 1986年 / 26卷 / 12期
关键词：
D O I：
10.1002/pen.760261208
中图分类号：
TQ [化学工业];
学科分类号：
0817 ;
摘要：
引用
收藏
页码：886 / 892
页数：7
相关论文
共 17 条
[1]  
Carlslaw HS, 1959, CONDUCTION HEAT SOLI
[2]   ANALYSIS OF THE PACKING STAGE IN INJECTION-MOLDING OF DISK CAVITIES [J].
CHUNG, TS ;
IDE, Y .
JOURNAL OF APPLIED POLYMER SCIENCE, 1983, 28 (09) :2999-3002
[3]   PRESSURE BUILDUP DURING THE PACKING STAGE OF INJECTION-MOLDING [J].
CHUNG, TS .
POLYMER ENGINEERING AND SCIENCE, 1985, 25 (12) :772-777
[4]   ORIENTATION DEVELOPMENT AND RELAXATION IN INJECTION-MOLDING OF AMORPHOUS POLYMERS [J].
DIETZ, W ;
WHITE, JL ;
CLARK, ES .
POLYMER ENGINEERING AND SCIENCE, 1978, 18 (04) :273-281
[5]   PRESSURE-INDUCED DENSIFICATION IN INJECTION-MOLDING [J].
GREENER, J .
POLYMER ENGINEERING AND SCIENCE, 1986, 26 (08) :534-542
[6]   ORIENTATION RESIDUAL-STRESSES AND BIREFRINGENCE IN INJECTION-MOLDING [J].
GREENER, J ;
PEARSON, GH .
JOURNAL OF RHEOLOGY, 1983, 27 (02) :115-134
[7]   INJECTION MOLDING BEHAVIOR OF THERMOPLASTICS IN THIN RECTANGULAR CAVITIES [J].
KAMAL, MR ;
KUO, Y ;
DOAN, PH .
POLYMER ENGINEERING AND SCIENCE, 1975, 15 (12) :863-868
[8]   INJECTION MOLDING OF THERMOPLASTICS .1. THEORETICAL MODEL [J].
KAMAL, MR ;
KENIG, S .
POLYMER ENGINEERING AND SCIENCE, 1972, 12 (04) :294-&
[9]   PACKING AND DISCHARGE IN INJECTION MOLDING [J].
KOITA, YT .
POLYMER ENGINEERING AND SCIENCE, 1974, 14 (12) :840-847
[10]  
MIDDLEMAN S, 1977, FUNDAMENTALS POLYM P, pCH11
12