A COMPARISON OF THE TENSILE STRENGTH OF PLASTIC PARTS PRODUCED BY A FUSED DEPOSITION MODELING DEVICE

被引：13

作者：

Beniak, Juraj ^{[1
]}

Krizan, Peter ^{[1
]}

Matus, Milos ^{[1
]}

机构：

[1] Slovak Univ Technol Bratislava, Fac Mech Engn, Inst Mfg Syst Environm Technol & Qual Management, Nam Slobody 17, Bratislava 81231, Slovakia

来源：

ACTA POLYTECHNICA | 2015年 / 55卷 / 06期

关键词：

Rapid Prototyping; FDM; Fused Deposition Modeling; 3D printer; additive manufacturing;

D O I：

10.14311/AP.2015.55.0359

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

Rapid Prototyping systems are nowadays increasingly used in many areas of industry, not only for producing design models but also for producing parts for final use. We need to know the properties of these parts. When we talk about the Fused Deposition Modeling (FDM) technique and FDM devices, there are many possible settings for devices and models which could influence the properties of a final part. In addition, devices based on the same principle may use different operational software for calculating the tool path, and this may have a major impact. The aim of this paper is to show the tensile strength value for parts produced from different materials on the Fused Deposition Modeling device when the horizontal orientation of the specimens is changed.

引用

页码：359 / 365

页数：7