CHARACTERISTICS OF PARTIAL LENGTH CIRCULAR PIN FINS AS HEAT-TRANSFER AUGMENTORS FOR AIRFOIL INTERNAL COOLING PASSAGES

被引：24

作者：

ARORA, SC

ABDELMESSEH, W

机构：

[1] Structures Analysis, Turbine, Pratt and Whitney Canada Inc., Longueuil, QC

来源：

JOURNAL OF TURBOMACHINERY-TRANSACTIONS OF THE ASME | 1990年 / 112卷 / 03期

关键词：

D O I：

10.1115/1.2927694

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

Pin fins are commonly used as heat transfer augmentors for internal cooling of turbine airfoils. These pins may extend from one wall to the other or may be segmented to meet specific requirements of removing the airfoil’s varying heat load. Three configurations of the partial pins were tested in a channel with aspect ratio 25:1 and the results are compared with those for the full pins. The array average heat transfer rate decreases linearly with increasing gap and is bounded by the value for full pins at one end and that for the smooth channel at the other. However, the local distribution of the Nusselt number and the average for each of the two walls depends on the configuration of the partial pins. The friction factor was lower for partial pins than for the full pins and also decreased with increasing gap. For the configuration with all partial pins on one wall, the friction factor was found to be the lowest, with no change in the corresponding heat transfer rate from a wall with pins. © 1990 by ASME.

引用

页码：559 / 565

页数：7

共 7 条

[1] Arora S.C., Abdel-Messeh W., Heat Transfer Experiments in High Aspect Ratio Rectangular Channel with Epoxied Short Pin Fins, (1983)
[2] Arora S.C., Abdel-Messeh W., Pressure Drop and Heat Transfer Characteristics of Circular and Oblong Low Aspect Ratio Pin Fins, AGARD Conference Proceedings 390, (1985)
[3] Kline S.J., McClintock F.A., Describing Uncertainties in Single Sample Experiments, Mechanical Engineering, 75, (1953)
[4] Peng Y., Heat Transfer and Friction Loss Characteristics of Pin Fin Cooling Configurations, ASME, Journal of Engineering for Gas Turbines and Power, 106, pp. 246-251, (1984)
[5] Sparrow E.M., Ramsey J.W., Heat Transfer and Pressure Drop for a Staggered Wall - Attached Array of Cylinders With Tip Clearance, Int. J. Heat Mass Transfer, 21, pp. 1369-1377, (1978)
[6] Steuber G.D., Metzger D.E., Heat Transfer and Pressure Loss Performance for Families of Partial Length Pin Fin Arrays in High Aspect Ratio Rectangular Ducts, Proceedings of Eight International Heat Transfer Conference, 6, pp. 2915-2920, (1986)
[7] Zukauskas A., Heat Transfer From Tubes in Crossflow, Advances in Heat Transfer, 8, pp. 93-160, (1972)

← 1 →