Tool wear and tool life of PCBN, binderless cBN and wBN-cBN tools in continuous finish hard turning of cold work tool steel

被引：0
作者：
V. M. Bushlya
O. A. Gutnichenko
J. M. Zhou
J. -E. Ståhl
S. Gunnarsson
机构：
[1] Lund University,Division of Production and Materials Engineering
[2] Uddeholm AB,undefined
来源：
Journal of Superhard Materials | 2014年 / 36卷
关键词：
CBN; wear; white layer; coldwork steels; hard turning;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
The paper presents the results of comparative study of performance of cutting tools made of ceramic-bound, binderless cBN, and wBN-cBN tool materials. The tool performance was assessed by tool wear-resistance, values of cutting forces, parameters of machined surface quality, and the state of sub-surface layer generated in continuous turning of hardened cold work tool steel. The tests were carried out under conditions of high speed machining (vc = 120–180 m/min) both with and without a coolant. The best tool performance by the above-mentioned criteria is provided by a low-cBN material with ceramic binder.
引用
收藏
页码：49 / 60
页数：11
相关论文
共 62 条
[1]  
Chou YK(2003)Hard Turning of M50 Steel with Different Microstructures in Continuous and Intermittent Cutting Wear 255 1388-1394
[2]  
Aslan E(2005)Experimental Investigation of Cutting Tool Performance in High Speed Cutting of Hardened X219 Cr12 Cold-Work Tool Steel (62 HRC) Mater. Design. 26 21-27
[3]  
Haplin T(2009)The Performance of Polycrystalline Cubic Boron Nitride Tools in Continuous, Semi-interrupted, and Interrupted Hard Machining J. Eng. Manuf. 223 947-953
[4]  
Byrne G(1996)On Chip Morphology, Tool Wear and Cutting Mechanisms in Finish Hard Turning Annals CIRP 45 77-81
[5]  
Barry J(2013)Effects of Cutting Speed When Turning Age Hardened Inconel 718 with PCBN Tools of Binderless and Low-cBN Grades Machining Sci. Techn. 17 497-523
[6]  
Ahearne E(2011)Tool Life and Surface Integrity Issues in Continuous and Interrupted Finish Hard Turning with Coated Carbide and CBN Tools J. Eng. Manuf. 226 431-444
[7]  
Davies MA(1995)Machining Ti6Al4V Alloy with a wBN-cBN Composite Tool Materials and Design 16 221-226
[8]  
Chou Y(1992)On the Wear Mechanism of Cubic Boron Nitride Base Cutting Tools Wear 157 1-7
[9]  
Evans CJ(2011)An In-depth Investigation of the Cutting Speed Impact on the Degraded Microstructure of Worn PCBN Cutting Tools Wear 271 2610-2618
[10]  
Bushlya V(2013)Wear Mechanisms of PVD-coated PCBN Cutting Tools Wear 302 1219-1229
1234567