A new approach to surface roughness and roundness improvement in wire electrical discharge turning based on statistical analyses

In this paper, the effects and the optimization of machining parameters on surface roughness and roundness in the turning wire electrical discharge machining (TWEDM) process are investigated. In the TWEDM process, a new machining parameter, such as rotational speed, is introduced, which changes the normal machining conditions in conventional wire electrical discharge machining (WEDM). By the Taguchi method, a complete realization of the process parameters and their effects were achieved. The Taguchi method has not been used in TWEDM by other researchers. The surface roughness and roundness were measured to verify the process. In addition, the open-circuit voltage, pulse-off time, open arc voltage, and the inter-electrode gap size, which are replaced by power, time-off, voltage, and servo, respectively, and also wire tension, wire speed, and rotational speed were chosen for evaluation by the Taguchi method. An L18 (21 × 37) Taguchi standard orthogonal array was chosen for the design of experiments. The level of importance of the machining parameters on the surface roughness and roundness was determined by using analysis of variance (ANOVA). The optimum machining parameters combination was obtained by using the analysis of signal-to-noise (S/N) ratios. The variation of surface roughness and roundness with machining parameters was mathematically modeled by using the regression analysis method. Finally, experimentation was carried out to identify the effectiveness of the proposed method. The presented model is also verified by a set of verification tests.