Sensitivity and effect of key operational parameters on performance of a dual-cylinder free-piston engine generator双缸型自由活塞内燃发电机关键运行参数的性能影响特性及敏感度分析

被引:0
作者
Zhi-yuan Zhang
Hui-hua Feng
Bo-ru Jia
Zheng-xing Zuo
机构
[1] Beijing Institute of Technology,School of Mechanical Engineering
来源
Journal of Central South University | 2022年 / 29卷
关键词
free piston engine generator; excess air ratio; ignition position; operation characteristics; sensitivity analysis; thermal efficiency; 自由活塞内燃发电机; 过量空气系数; 点火位置; 运行特性; 敏感度分析; 热效率;
D O I
暂无
中图分类号
学科分类号
摘要
The free-piston engine generator (FPEG) is regarded as the next generation of energy conversion system which may replace traditional engines in the future. The effect of key operational parameters like excess air ratio of input mixture and ignition position on the engine performance of a dual-cylinder FPEG was investigated, and their sensitivity was analyzed in this paper. The operating compression ratio of the system is susceptible to changes in excess air ratio and ignition position. At the same time, it decreases from 15.8 to 6.6 when excess air ratio increases from 0.85 to 1.15, but it increases from 6.1 to 13.3 as ignition position increases from 15 mm to 20 mm. The operating frequency and indicated power are more sensitive to changes in excess air ratio than ignition position. But it is the opposite for the indicated thermal efficiency and friction loss. Excess air ratio and ignition position have a quite similar influence on heat transfer. Therefore, from the perspective of system operation and performance, it is preferable to keep excess air coefficient slightly below 1.0. In contrast, when selecting ignition position, it is of great importance to comprehensively consider the risk of structural damage caused by the increase in the compression ratio and in-cylinder gas pressure.
引用
收藏
页码:2101 / 2111
页数:10
相关论文
共 83 条
[1]  
Mikalsen R(2007)A review of free-piston engine history and applications [J] Applied Thermal Engineering 27 2339-2352
[2]  
Roskilly A P(2018)A study and comparison of frictional losses in free-piston engine and crankshaft engines [J] Applied Thermal Engineering 140 217-224
[3]  
Jia B(2016)Design and simulation of a two- or four-stroke free-piston engine generator for range extender applications [J] Energy Conversion and Management 111 289-298
[4]  
Mikalsen R(2015)Recent commercial free-piston engine developments for automotive applications [J] Applied Thermal Engineering 75 493-503
[5]  
Smallbone A(2014)Asymmetric vibration characteristics of two-cylinder four-stroke single-piston hydraulic free piston engine [J] Journal of Central South University 21 3762-3768
[6]  
Jia B(2015)An experimental investigation into the starting process of free-piston engine generator [J] Applied Energy 157 798-804
[7]  
Smallbone A(2017)Disturbance analysis of a free-piston engine generator using a validated fast-response numerical model [J] Applied Energy 185 440-451
[8]  
Zuo Z(2020)A starting control strategy of single-cylinder two-stroke free-piston engine generator [J] Journal of Engineering for Gas Turbines and Power 142 031020-326
[9]  
Hanipah M R(2015)Modeling of piston trajectory-based HCCI combustion enabled by a free piston engine [J] Applied Energy 139 313-2016
[10]  
Mikalsen R(2022)Optimisation of operating parameters on the performance characteristics of a free piston engine linear generator fuelled by CNG-H International Journal of Hydrogen Energy 47 1996-57