Influence of White Aluminum Dross on the Corrosion Resistance of Reinforcement Carbon Steel in Simulated Concrete Pore Solution

被引：0
作者：
Loto R.T. [1 ]
Busari A. [2 ]
机构：
[1] Department of Mechanical Engineering, Covenant University, Ota, Ogun State
[2] Department of Civil Engineering, Covenant University, Ota, Ogun State
来源：
Journal of Bio- and Tribo-Corrosion | 2019年 / 5卷 / 01期
关键词：
Aluminum; Concrete; Corrosion; Pitting; Steel;
D O I：
10.1007/s40735-018-0211-7
中图分类号：
学科分类号：
摘要：
Recent research in concrete technology now focuses on partial replacement of cement using cost-effective, eco-friendly and sustainable wastes and admixtures. The effect of white aluminum dross (Al-D) at 0%, 5%, 10%, 15%, 20% and 25% weight concentration on the corrosion resistance of low carbon steel in simulated concrete pore solution was studied with potentiodynamic polarization technique and open circuit potential (OCP) measurement. Optical microscopy was used to analyze and compare the surface morphology of the steel specimens before and after the corrosion test. Results from electrochemical test showed Al-D in concrete admixture mildly increases the corrosion rate of the carbon steel with respect to Al-D concentration. Corrosion rate values of 3.00 × 102, 3.41 × 102 and 8.39 × 102 were obtained at 0%, 5% and 25% Al-D. Cathodic shift in corrosion potential was observed due to selective deterioration of the steel. However, potentiostatic data show the presence of Al-D extends the passivation range of the carbon steel, improving its pitting corrosion. OCP plots with and without shift significantly to positive values with respect to exposure time signifying formation of protective oxide on the carbon steel. Severe morphological deterioration in the form of corrosion pits are visible on steel surface from concrete pore electrolyte at 0% Al-D. Fewer and comparatively smaller corrosion pits are visible on the morphology of the steel from 5% Al-D pore electrolyte. The relative size of the corrosion pits decreased further from observation of the steel from pore solution at 25% Al-D. © 2018, Springer Nature Switzerland AG.
引用
收藏
相关论文
共 53 条
[1]  
Ahmad S., Reinforcement corrosion in concrete structures, its monitoring and service life prediction—a review, Cem Concr Compos, 25, 4-5, pp. 459-471, (2003)
[2]  
Biezma M.V., San J.R., Cristobal, Methodology to study cost of corrosion, Corros Eng Sci Technol, 40, 4, pp. 344-352, (2005)
[3]  
Thangavel K., The threshold limit for chloride corrosion of reinforced concrete, Corros Rev, 22, 1, pp. 55-70, (2004)
[4]  
Zheng H., Li W., Ma F., Kong Q., The effect of a surface-applied corrosion inhibitor on the durability of concrete, Constr Build Mater, 37, pp. 36-40, (2012)
[5]  
Bastidas D.M., Criado M., Fajardo S., La Iglesia A., Bastidas J.M., Corrosion inhibition mechanism of phosphates for early-age reinforced mortar in the presence of chlorides, Cem Concr Compos, 61, pp. 1-6, (2015)
[6]  
Conciatori F., Laferrier E., Brruhwiler, Comprehensive modeling of chloride ion and water ingress into concrete considering thermal and carbonation state for real climate, Cem Concr Res, 40, 1, pp. 109-118, (2010)
[7]  
Etteyeb N., Novoa X.R., Inhibition effect of some trees cultivated in arid regions against the corrosion of steel reinforcement in alkaline chloride solution, Corros Sci, 112, pp. 471-482, (2016)
[8]  
Loto C.A., Joseph O.O., Loto R.T., Inhibition effect of Vernonia amygdalina extract on the corrosion of mild steel reinforcement in concrete in 0.2M H<sub>2</sub>SO<sub>4</sub> environment, Eur J Environ Civ Eng, 17, 10, pp. 1026-1038, (2013)
[9]  
Loto R.T., Loto C.A., Fedotova T., Electrochemical studies of mild steel corrosion inhibition in sulfuric acid chloride by aniline, Res Chem Intermed, 40, 4, pp. 1501-1516, (2014)
[10]  
Loto C.A., Loto R.T., Effect of dextrin and thiourea additives on the zinc electroplated mild steel in acid chloride solution, Int J Electrochem Sci, 8, 12, pp. 12434-12450, (2013)
123456