Wear behavior of nanocrystalline Cu-Zn alloy

被引：0

作者：

Xiaoli Kong

Lijie Qiao

Yongbing Liu

机构：

[1] University of Science and Technology Beijing,Department of Materials Physics

[2] Jilin University,College of Materials Science and Engineering, Nanling Campus

来源：

Journal of Materials Engineering and Performance | 2003年 / 12卷

关键词：

nanocrystalline Cu-Zn alloy; surface film; wear resistance;

D O I：

暂无

中图分类号：

学科分类号：

摘要：

The wear behaviors of nanocrystalline Cu-Zn alloy were investigated. Sliding wear tests were performed on a pin-on-disk test machine under dry conditions. Results indicated that nanocrystalline Cu-Zn alloy annealed at 300 °C exhibited better wear resistance and high load-bearing capacity than those in the as-pressed state. A surface film almost covering the entire worn surface was formed for nanocrystalline Cu-Zn alloy annealed at 300 °C at a load range from 2.1–5.6 MPa. The surface film effectively improves the wear resistance of nanocrystalline Cu-Zn alloy.

引用

页码：312 / 316

页数：4

共 10 条

[1]

Sun X.K.(2000)Preparation and Mechanical Properties of Highly Densified Nanocrystalline Al Metall. Mater. Trans. 31A 1017-24

[2]

Cong H.T.(1999)Wear of Copper and Its Alloys With Submicrocrystalline Structure Wear 225–229 649-55

[3]

Sun M.(1999)The Influence of Strain-Heat Processing on Copper Wear Wear 212 160-64

[4]

Yang M.C.(undefined)undefined undefined undefined undefined-undefined

[5]

Sadykov F.A.(undefined)undefined undefined undefined undefined-undefined

[6]

Barykin N.P.(undefined)undefined undefined undefined undefined-undefined

[7]

Aslanyan I.R.(undefined)undefined undefined undefined undefined-undefined

[8]

Sadykov F.A.(undefined)undefined undefined undefined undefined-undefined

[9]

Barykin N.P.(undefined)undefined undefined undefined undefined-undefined

[10]

Aslanyan I.R.(undefined)undefined undefined undefined undefined-undefined

← 1 →