Friction and Wear Behavior of Copper Matrix Composites Reinforced with SiC and Graphite Particles

被引：3
作者：
Yongzhong Zhan
Guoding Zhang
机构：
[1] Shanghai Jiao Tong University,State Key Laboratory of Metal Matrix Composites
来源：
Tribology Letters | 2004年 / 17卷
关键词：
copper matrix composites; SiC particles; graphite particles; friction and wear; mechanically mixed layer;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
The objective of this paper is to investigate the friction behavior and wear mechanism of copper matrix composites reinforced with SiC and graphite particles. The results indicate that a graphite-rich mechanically mixed layer (MML) formed on the tribo-surface was responsible for the good tribological properties of the hybrid composites at low normal loads. When graphite content was high enough for delamination wear to take place at high load, wear resistance deteriorated. A continuous supply of graphite to the tribo-surface is an important precondition for the formation of a graphite-rich MML and the benefit of its anti-friction properties for the copper hybrid composites.
引用
收藏
页码：91 / 98
页数：7
相关论文
共 50 条
[11]   The friction and wear of electroless Ni-P matrix with PTFE and/or SiC particles composite [J].
Wu, YT ;
Liu, HZ ;
Shen, B ;
Liu, L ;
Hu, WB .
TRIBOLOGY INTERNATIONAL, 2006, 39 (06) :553-559
[12]   The fabrication and property of SiC fiber reinforced copper matrix composites [J].
Luo, X. ;
Yang, Y. Q. ;
Liu, Y. C. ;
Ma, Z. J. ;
Yuan, M. N. ;
Chen, Y. .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2007, 459 (1-2) :244-250
[13]   Mechanical properties, wear and corrosion behavior of copper matrix composites reinforced with steel machining chips [J].
Alaneme, Kenneth Kanayo ;
Odoni, Benjamin Ufuoma .
ENGINEERING SCIENCE AND TECHNOLOGY-AN INTERNATIONAL JOURNAL-JESTECH, 2016, 19 (03) :1593-1599
[14]   Electrical wear performance of copper matrix composites reinforced with hybrid CNTs and TiB2 particles [J].
Yang, Yubo ;
Guo, Xiuhua ;
Song, Kexing ;
Long, Fei ;
Wang, Xu ;
Li, Shaolin ;
Li, Zhou .
INDUSTRIAL LUBRICATION AND TRIBOLOGY, 2022, 74 (06) :609-618
[15]   Dry sliding friction and wear behavior of bronze matrix composites reinforced with Ni3Al particles: Comparison with conventional brake lining [J].
Celikyurek, Ibrahim ;
Bicer, Aytac .
INTERNATIONAL JOURNAL OF MATERIALS RESEARCH, 2016, 107 (09) :835-841
[16]   Electrical conductivity anisotropy of copper matrix composites reinforced with SiC whiskers [J].
Feng, Jiang ;
Liang, Shuhua ;
Guo, Xiuhua ;
Zhang, Yi ;
Song, Kexing .
NANOTECHNOLOGY REVIEWS, 2019, 8 (01) :285-292
[17]   Friction and wear behavior of SiC particles deposited onto paper-based friction material via electrophoretic deposition [J].
Fei, Jie ;
Luo, Dan ;
Zhang, Chao ;
Li, Hejun ;
Cui, Yali ;
Huang, Jianfeng .
TRIBOLOGY INTERNATIONAL, 2018, 119 :230-238
[18]   Microstructure and wear characterization of rice husk ash reinforced copper matrix composites prepared using friction stir processing [J].
Dinaharan, I. ;
Kalaiselvan, K. ;
Akinlabi, E. T. ;
Paulo Davim, J. .
JOURNAL OF ALLOYS AND COMPOUNDS, 2017, 718 :150-160
[19]   Friction and wear behavior of Mg2B2O5w, SiC and Gr particles reinforced 6061Al matrix composite [J].
Ding, Yu-Tian ;
Wang, Dong-Qiang ;
Hu, Yong ;
Peng, He-Si ;
Ma, Guo-Jun .
Cailiao Gongcheng/Journal of Materials Engineering, 2015, 43 (10) :42-48
[20]   Damping capacities and tensile properties of magnesium matrix composites reinforced by graphite particles [J].
Wu, Y. W. ;
Wu, K. ;
Deng, K. K. ;
Nie, K. B. ;
Wang, X. J. ;
Hu, X. S. ;
Zheng, M. Y. .
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2010, 527 (26) :6816-6821
12345