Structure and surface properties of fluorinated organic–inorganic hybrid films

Fluorinated organic–inorganic hybrid films were prepared by sol–gel process from tridecafluoroctyltriethoxysilane (PFAS), 3-glycidoxypropyltrimethoxysilane, and tetraethoxysilane (TEOS). It has been found that the fluorinated hybrid films possessed fluorinated side chains originating from PFAS as top layer, and silica network as bottom layer, which had very low surface energy and could be used as water repellent functional coatings. The outermost layer of the water-repellent film may be fully covered by the perfluoroalkyl side chains as the molar ratio of PFAS/TEOS increases up to about 0.005:1. The addition of BPA can enhance the cross-link density of fluorinated hybrid films, and make more perfluoroalkyl groups enriching at the coating film-air interface to lower the surface free energy. However, the improvement of the cross-link density of fluorinated hybrid films tends to exhibit brittleness and micro-cracks. Consequently, it can be concluded that a small BPA additive content is preferred for the formation of fluorinated hybrid films with a smooth surface and less detectable cracks.