Additive Manufacturing Based on Welding Arc: A low-Cost Method

被引：64

作者：

Wang Y. ^{[1
,2
]}

Chen X. ^{[1
,2
]}

Konovalov S.V. ^{[1
,2
]}

机构：

[1] School of Mechanical and Electrical Engineering, Wenzhou University, Chashan Education Town, Wenzhou, Zhejiang

[2] Department of Metals Technology and Aviation Materials, Samara National Research University, Samara

来源：

Journal of Surface Investigation: X-ray, Synchrotron and Neutron Techniques | 2017年 / 11卷 / 6期

关键词：

Additive manufacturing; CAD; modeling processes; Surface Quality; welding;

D O I：

10.1134/S1027451017060210

中图分类号：

学科分类号：

摘要：

The objective of this paper is to present a review of a new developing manufacturing technology based on welding of metallic materials. Additive manufacturing (AM) is based on robot welding and it has showed the high flexibility, efficiency, fast output, good quality and low cost. This paper explores several common welding materials and manufacturing technologies include the shield gas, materials engineering, processes and most concerned commercial interests. AM has the potential to revolutionize the global parts manufacturing and industrial tendencies with the rapid development of increasing material manufacturing technology. AM based on arc welding has the big advantages of high efficiency and low cost, which makes it possible to use in many industries although it has a little bit poor surface qualities compare to AM based on laser and electron beam manufacturing. © 2017, Pleiades Publishing, Ltd.

引用

页码：1317 / 1328

页数：11

共 50 条

[1]

Alcisto A., Enriquez A., Garcia H., Hinkson S., Steelman T., Silverman E., Valdovino P., Gigerenzer H., Foyos J., Ogren J., Dorey J., Karg K., McDonald T., Es-Said O.S., J. Mater. Eng. Perform., 20, 2, (2011)

[2]

Hohnann D.C., Roherts S., Otis R., Kolodziejska J., Dillon R.P., Suh J.-O., Shapiro A.A., Liu Z.-K., Borgonia L.-P., Sci. Rep., 45357, (2014)

[3]

Lewis G.K., Schlienger E., Mater. Des., 21, 4, (2000)

[4]

Taminger K.M.B., Hafley R.A., Electron Beam Freeform Fabrication: A Rapid Metal Deposition Process, (2003)

[5]

Sequeira Almeida P.M., Williams S., Proc. 21st Annual Int. Solid Freeform Fabrication Symposium: An Additive Manufacturing Conference, (2010)

[6]

Ding J., Colegrove P., Mehnen J., Ganguly S., Sequeira P.M., Wang P., Et al., Comput. Mater. Sci., 50, 12, (2011)

[7]

Wang C., Williams S., Rush M., Int. J. Adv. Manuf. Technol., 57, 5, (2011)

[8]

Jun X., Guangjun Z., Forming Characteristics in Multi-Layer Single-Bead GMA Additive Manufacturing and Control for Deposition Dimension, (2014)

[9]

Bi G., Gasser A., Phys. Procedia, 12, 1, (2011)

[10]

Unocic R., Dupont J., Metall. Mater. Trans. B, 35, 1, (2004)

← 1 2 3 4 5 →