Methods to Increase Fault Tolerance of Combinational Integrated Microcircuits by Redundancy Coding

被引：1

作者：

Gavrilov S.V. ^{[1
]}

Gurov S.I. ^{[2
,3
]}

Zhukova T.D. ^{[1
]}

Rukhlov V.S. ^{[2
,3
]}

Ryzhova D.I. ^{[1
]}

Tel’pukhov D.V. ^{[2
,3
]}

机构：

[1] Institute for Design Problems in Microelectronics of Russian Academy of Sciences, Moscow

[2] Faculty of Computational Mathematics and Cybernetics, Moscow State University, Moscow

[3] Faculty of Computational Mathematics and Cybernetics, Moscow State University, Moscow

来源：

Computational Mathematics and Modeling | 2017年 / 28卷 / 3期

关键词：

coding of information; combinational circuits; fault tolerance;

D O I：

10.1007/s10598-017-9372-3

中图分类号：

学科分类号：

摘要：

Increasing the operating reliability of integrated microcircuits (IMC) remains, on the whole, an unsolved design problem. An important aspect of this problem is the stability of the circuits under transient faults (malfunctions) in large integrated circuits. Faults appear due to various disturbances: radiation, supply voltage jumps, signal degradation over time, etc. Investigations show that the probability of an error due to these factors may vary between very wide limits: from less than 0.1% for large circuits and up to 30% for very small circuits. In this article, we consider various methods of enhancing the fault tolerance of combinational circuits and also assess the effect of a single fault and a stuck-at fault on circuit operation for the case of combinational circuits from the ISCAS’85 set. © 2017, Springer Science+Business Media, LLC.

引用

页码：400 / 406

页数：6

共 50 条

[21] Modeling & Analysis of Redundancy based Fault Tolerance for Permanent Faults in Chip Multiprocessor Cache
Choudhury, Avishek
Sikdar, Biplab K.
2018 31ST INTERNATIONAL CONFERENCE ON VLSI DESIGN AND 2018 17TH INTERNATIONAL CONFERENCE ON EMBEDDED SYSTEMS (VLSID & ES), 2018, : 115 - 120
[22] Improvement of the Fault Tolerance in IoT Based Positioning Systems by Applying for Redundancy in the Controller Layer
Al-Salihi, Nawzad K.
BAGHDAD SCIENCE JOURNAL, 2021, 18 (04) : 1303 - 1316
[23] Computation Offloading and Task Scheduling with Fault-Tolerance for Minimizing Redundancy in Edge Computing
Liu, Xinying
Jiang, Jianhui
Li, Long
2021 IEEE INTERNATIONAL SYMPOSIUM ON SOFTWARE RELIABILITY ENGINEERING WORKSHOPS (ISSREW 2021), 2021, : 198 - 209
[24] Enhancing Sensor Fault Tolerance in Automotive Systems With Cost-Effective Cyber Redundancy
Foshati, Amin
Ejlali, Alireza
IEEE TRANSACTIONS ON INTELLIGENT VEHICLES, 2024, 9 (04): : 4794 - 4803
[25] Rigorous fault tolerance using aspects and formal methods
Katz, Shmuel
RIGOROUS DEVELOPMENT OF COMPLEX FAULT-TOLERANT SYSTEMS, 2006, 4157 : 226 - 240
[26] Intrinsic fault tolerance of multilevel Monte Carlo methods
Pauli, Stefan
Arbenz, Peter
Schwab, Christoph
JOURNAL OF PARALLEL AND DISTRIBUTED COMPUTING, 2015, 84 : 24 - 36
[27] A Priori methods for Fault Tolerance in Wireless Sensor Networks
Bellalouna, Monia
Ghabri, Afef
WORLD CONGRESS ON COMPUTER & INFORMATION TECHNOLOGY (WCCIT 2013), 2013,
[28] A Study on Byzantine Fault Tolerance Methods in Distributed Networks
Nasreen, M. A.
Ganesh, Amal
Sunitha, C.
FOURTH INTERNATIONAL CONFERENCE ON RECENT TRENDS IN COMPUTER SCIENCE & ENGINEERING (ICRTCSE 2016), 2016, 87 : 50 - 54
[29] Fully Integrated Fault-tolerance for PMSMs in Aviation Applications
Thurlbeck, Alastair P.
Cao, Yue
2020 IEEE ENERGY CONVERSION CONGRESS AND EXPOSITION (ECCE), 2020, : 4916 - 4922
[30] An Integrated Virtualized Strategy for Fault Tolerance in Cloud Computing Environment
Mohammed, Bashir
Kiran, Mariam
Awan, Irfan-Ullah
Maiyama, Kabiru M.
2016 INT IEEE CONFERENCES ON UBIQUITOUS INTELLIGENCE & COMPUTING, ADVANCED & TRUSTED COMPUTING, SCALABLE COMPUTING AND COMMUNICATIONS, CLOUD AND BIG DATA COMPUTING, INTERNET OF PEOPLE, AND SMART WORLD CONGRESS (UIC/ATC/SCALCOM/CBDCOM/IOP/SMARTWORLD), 2016, : 542 - 549

← 1 2 3 4 5 →