Effect of deposition time on sputtered ZnO thin films and their gas sensing application

被引:0
作者
Sonik Bhatia
Neha Verma
Munish Aggarwal
机构
[1] Kanya Maha Vidyalaya,PG Department of Physics
[2] IKG Punjab Technical University,undefined
[3] Lyallpur Khalsa College of Engineering,undefined
来源
Journal of Materials Science: Materials in Electronics | 2018年 / 29卷
关键词
D O I
暂无
中图分类号
学科分类号
摘要
Nowadays, advanced industrialization and population growth have led to increasing the environmental related issues. This paper reports the effect of deposition time on ZnO films deposited on to the glass substrate by using rf magnetron sputtering technique and their further use for gas sensing applications. Herein, deposition time is considered to be changed from 300 s, 800 s (S1, S2). The thickness of deposited films lies in the range of 130–180 nm. The synthesized films were characterized by various techniques in terms of structural, morphological, optical and gas sensing properties. The typical crystal size of ZnO films was found to be in the range of 15–27 nm. FESEM analysis revealed the growth of nanospheres was lies in the range of 80–120 nm. Fourier transform infrared spectroscopy confirmed the ZnO bonding located at a wavelength of 430 cm−1. The average optical transmittance of the film was about 90–95% in the visible range. The optical band gap of ZnO films was decreased from 3.31 to 3.29 eV. The detailed characterization study showed 800 s is an optimum deposition time for good optoelectronic properties. For gas sensing application, highest sensitivity was obtained at operating temperature of 205 °C. Prepared films have a quick response and fast recovery time in the range of 128 s and 163 s respectively. These response and recovery time characteristics were explained by valence ion mechanism.
引用
收藏
页码:18136 / 18143
页数:7
相关论文
共 117 条
[1]  
Singh G(2011)Effect of indium doping on zinc oxide films prepared by chemical spray pyrolysis technique Bull. Mater. Sci. 33 581-587
[2]  
Shrivastava SB(2003)Fabrication and characterization of n -ZnO Õ p-AlGaN heterojunction light-emitting diodes on 6H-SiC substrates Appl. Phys. Lett. 83 4719-4721
[3]  
Jain D(2015)New efficient solar cell structures based on zinc oxide nanorods Sol. Energy Mater. Sol. Cells 143 99-104
[4]  
Alivov YI(2016)A surface oxide thin layer of copper nanowires enhanced the UV selective response of a ZnO film photodetector J. Mater. Chem. C 4 8416-8421
[5]  
Pietruszka R(2008)Structural and optical properties of a-plane ZnO thin films synthesized on gamma-LiAlO(2) (302) substrates by low-pressure metal-organic chemical vapor deposition Thin Solid Films 516 6079-6082
[6]  
Witkowski BS(2015)Characterization of ZnO films based sensors prepared by different techniques Appl. Mech. Mater. 772 50-54
[7]  
Gieraltowska S(2012)Synthesis of ZnO:Al transparent conductive thin films using sol-gel method Procedia Eng. 36 54-61
[8]  
Teng F(2011)Preparation of nanocrystalline thin films of ZnO by sol-gel dip coating Bulg. Chem. Commun. 43 259-263
[9]  
Zheng L(2016)Optical application of Er-doped ZnO nanoparticles for photodegradation of direct red-31 dye Opt. Mater. 62 392-398
[10]  
Hu K(2016)Effect of RF power on the structural, optical and gas sensing properties of RF-sputtered Al doped ZnO thin films RSC Adv 6 9779-9788