Low speed lifting cable diagnosis using instantaneous angular speed

被引：0
作者：
Souha Khadraoui
Fabrice Bolaers
Olivier Cousinard
Jean Paul Dron
机构：
[1] University of Reims Champagne-Ardenne,Institute of Thermics Mechanics and Materials
来源：
Journal of Mechanical Science and Technology | 2021年 / 35卷
关键词：
Instantaneous angular speed; Lifting cable defects; Low rotation speed; Statistical indicators;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
This paper describes an experimental study of lifting cable fault diagnostic based on instantaneous angular speed (IAS) technique. During the study load tests on a selection of damaged cables, it is shown that IAS increases significantly after the damage is inflicted. The relationship between IAS signal characteristics and strand defects is investigated and it is found that the most influent parameters over IAS are speed, load and defects size. The pattern of IAS signals during a detection fault test is studied and a suggestion is made for a filtering technique to improve the recognition of imminent failure. Finally, an evaluation of the common statistical indicators was implemented. The study gave satisfactory results and shown that IAS measurement is a promising tool for the health monitoring of low speed cables.
引用
收藏
页码：1821 / 1828
页数：7
相关论文
共 58 条
[1]  
Gao G(2015)Detecting typical defects in wire ropes through wavelet analysis Insight - Non-Destructive Testing and Condition Monitoring 57 98-105
[2]  
Qin Y(2000)Loss of metallic area in winder ropes subject to external wear Engineering Failure Analysis 7 197-200
[3]  
Lian M(1997)A review of the acoustic-emission monitoring of wire rope Ocean Engineering 24 935-947
[4]  
Liu Y(1988)Wire breaks detection during the tensile fatigue testing of 40 mm diameter wire rope British Journal of Non-Destructive Testing 30 338-341
[5]  
Kuruppu M D(2008)Adaptive combined HOEO based fault feature extraction method for rolling element bearing under variable speed condition Journal of Mechanical Science and Technology 32 4589-4599
[6]  
Tytko A(2014)Low speed bearings fault detection and size estimation using instantaneous angular speed Journal of Vibration and Control 22 3413-3425
[7]  
Golosinski T S(2006)An investigation of the effects of measurement noise in the use of instantaneous angular speed for machine diagnosis Mechanical Systems and Signal Processing 20 1444-1460
[8]  
Casey N F(2012)Intelligent fault diagnosis method for marine diesel engines using instantaneous angular speed Journal of Mechanical Science and Technology 26 2413-2423
[9]  
Laura P A A(2010)A data processing method for determining instantaneous angular speed and acceleration of crankshaft in an aircraft engine-propeller system using a magnetic encoder Mechanical Systems and Signal Processing 24 1032-1048
[10]  
Casey N F(2014)Indicators for monitoring chatter in milling based on instantaneous angular speeds Mechanical Systems and Signal Processing 44 72-85
123456