Laser-induced periodic surface structures on different poly-carbonate films

Laser-induced periodic surface structures (LIPSS) were generated on oriented and amorphous thick, as well as on spin-coated thin, poly-carbonate films by polarized ArF excimer laser light. The influence of the film structure and thickness on the LIPSS formation was demonstrated. Below a critical thickness of the spin-coated films the line-shaped structures transformed into droplets. This droplet formation was explained by the laser-induced melting across the whole film thickness and subsequent de-wetting on the substrate. The thickness of the layer melted by laser illumination was computed by a heat-conduction model. Very good agreement with the critical thickness for spin-coated films was found. The original polymer film structure influences the index of refraction of the thin upper layer modified by the laser treatment, as was proven by the dependence of the structure’s period on the angle of incidence both for ‘s’- and ‘p’-polarized beams. The effect of the original surface roughness – grains in thick films or holes in thin films – was studied using atomic force microscopy. It was shown that the oblique incidence of ‘s’-polarized beams results in an intensity confinement in the direction of the forward scattering and in asymmetrical interference pattern formation around these irregularities. A new, two-dimensional grating-like structure was generated on spin-coated films. These gratings might be used as a special kind of mask.