Optimization of turning parameters for surface roughness and tool life based on the Taguchi method

被引：0
作者：
Ahmet Hasçalık
Ulaş Çaydaş
机构：
[1] University of Firat,Department of Manufacturing
[2] Technical Education Faculty,undefined
来源：
The International Journal of Advanced Manufacturing Technology | 2008年 / 38卷
关键词：
Surface roughness; Tool life; Taguchi method; Analysis of variance; Ti-6Al-4V;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
In this study, the effect and optimization of machining parameters on surface roughness and tool life in a turning operation was investigated by using the Taguchi method. The experimental studies were conducted under varying cutting speeds, feed rates, and depths of cut. An orthogonal array, the signal-to-noise (S/N) ratio, and the analysis of variance (ANOVA) were employed to the study the performance characteristics in the turning of commercial Ti-6Al-4V alloy using CNMG 120408-883 insert cutting tools. The conclusions revealed that the feed rate and cutting speed were the most influential factors on the surface roughness and tool life, respectively. The surface roughness was chiefly related to the cutting speed, whereas the axial depth of cut had the greatest effect on tool life.
引用
收藏
页码：896 / 903
页数：7
相关论文
共 22 条
[1]  
Ramulu M(2001)A study on the drilling of composite and titanium stacks Compos Struct 54 67-77
[2]  
Branson T(2005)The effect of machining on surface integrity of titanium alloy Ti-6Al-4V J Mater Process Technol 166 188-192
[3]  
Kim D(2005)Optimization of cutting conditions during continuous finished profile machining using non-traditional techniques Int J Adv Manuf Technol 26 30-40
[4]  
Haron CHC(2003)Analysis of process parameters in surface grinding with graphite as lubricant based on the Taguchi method J Mater Process Technol 141 51-59
[5]  
Jawaid A(1998)Design optimization of cutting parameters for turning operations based on the Taguchi method J Mater Process Technol 84 122-129
[6]  
Saravanan R(2002)Optimization technique for face milling stainless steel with multiple performance characteristics Int J Adv Manuf Technol 19 330-335
[7]  
Sankar RS(2006)Application of Taguchi method in the optimization of cutting parameters for surface roughness in turning Mater Des 28 1379-1385
[8]  
Asokan P(2001)Machining of aerospace titanium alloys Robot Comput Integr Manuf 17 99-106
[9]  
Vijayakumar K(2004)A study on kerf and material removal rate in wire electrical discharge machining based on Taguchi method J Mater Process Technol 152 316-322
[10]  
Prabhaharan G(undefined)undefined undefined undefined undefined-undefined
123