Effect of sintering temperature on the room temperature properties of Al90Mn8Ce2 alloy

被引：0
作者：
Z. K. Zhao
J. C. Li
Q. Jiang
机构：
[1] Jilin University,Laboratory of Automobile Materials of Ministry of Education and Department of Materials Science and Engineering
来源：
Journal of Materials Engineering and Performance | 2002年 / 11卷
关键词：
aluminum alloy; mechanical properties; sintering;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
Using a powder hot-pressing technique, a high-strength Al-8Mn-2Ce alloy (atomic percent (at.%)) in a size of φ20 × 10 mm has been made. The parameters used to obtain the highest strength of 895 MPa for the alloys are a pressing temperature of 803 K, a pressing time of 15 min, and a pressing stress of 1.2 GPa.
引用
收藏
页码：262 / 264
页数：2
相关论文
共 29 条
  • [1] Cahn R.W.(1989)Aluminium-Based Glassy Alloys Nature 341 183-84
  • [2] Inoue A.(1998)Amorphous, Nanoquasicrystalline and Nanocrystalline Alloys in Al-Based Systems Prog. Mater. Sci. 43 365-517
  • [3] Inoue A.(2000)Stabilization of Metallic Supercooled Liquid and Bulk Amorphous Alloys Acta Mater. 48 279-306
  • [4] Schurack F.(2001)Synthesis and Mechanical Properties of Cast Quasicrystal-Reinforced Al-Alloys Acta Mater. 49 1351-61
  • [5] Eckert J.(1993)High Mechanical Strength of Rapidly Solidified Al Mater. Trans. JIM 34 162-68
  • [6] Schultz L.(1998)Mn Mater. Sci. Eng. A 247 51-57
  • [7] Watanabe M.(1996)Ln Mater. Trans. JIM 37 1287-92
  • [8] Inoue A.(2002) (Ln=Lanthanide Metal) Alloys with Finely Mixed Icosahedral and Al Phases Mater. Res. Bull. 37 297-304
  • [9] Kimura H.M.(1997)An Investigation of the Microstructure and Mechanical Behavior of Novel Nanocrystalline Al-Fe-V-Si-Mm Alloy Ribbons J. Mater. Sci. Technol. 13 284-88
  • [10] Wang J.Q.(1999)High Mechanical Strength of Al-(V,Cr,Mn)-(Fe,Co,Ni) Quasicrystalline Alloys Prepared by Rapid Solidification T. Nonferr. Metal. Soc. China 9 48-51
123