Effects of ZnO composition on structure, optical and electrical properties of cosputtering In2O3–Ga2O3–ZnO films

被引:0
作者
Yih-Shing Lee
Chih-Wei Wang
Yuan-Zhe Lin
Cheng-Chung Jaing
机构
[1] Minghsin University of Science and Technology,Department of Optoelectronic System Engineering
[2] Minghsin University of Science and Technology,Institute of Electronics
来源
Journal of Materials Science: Materials in Electronics | 2016年 / 27卷
关键词
Residual Stress; In2O3; Ga2O3; Deposition Power; Polycrystalline Phase;
D O I
暂无
中图分类号
学科分类号
摘要
This study investigated the impacts of structure, optical and electrical properties of indium–gallium–zinc oxide (IGZO) film with varied ZnO deposition powers on glass substrates by using cosputtering system with two radio-frequency (RF) (ZnO and Ga2O3) and one direct-current (DC) (In2O3) magnetron. The average transmittance decreased obviously from 86.37 to 81.44 % and the optical energy gap decreased from 3.56 to 3.29 eV when ZnO deposition power increases. Results are ascribed to facts that the content of Zn in IGZO films was increased and the fitting extinction coefficient near the wavelength in the range of 370–450 nm obviously increased with increase of ZnO deposition power; the fitting refractive index of IGZO films was noticeably increased and surface morphology displayed a dense structure. The crystallinities of IGZO films reveal from an amorphous structure with a content of Zn less than 50 at.% to a polycrystalline phase of IGZO film with a content of Zn around 70.5 at.%. The residual stress of the indium gallium oxide (IGO) films with undoped ZnO content significantly changed from a tensile stress to a compressive stress with an increased annealing temperature. When the ZnO composition incorporated into the IGO film, variations of the residual stress in the films gradually become smaller. The optimum process condition of cosputtering IGZO films with a ZnO deposition power at 100 W and an annealing temperature at 300 °C showed the largest film mobility, smallest surface roughness, and a lower residual stress.
引用
收藏
页码:11470 / 11477
页数:7
相关论文
共 50 条
  • [31] Heavy-ion irradiation effects on U3O8 incorporated Gd2Zr2O7 waste forms
    Lu, Xirui
    Shu, Xiaoyan
    Chen, Shunzhang
    Zhang, Kuibao
    Chi, Fangtin
    Zhang, Haibin
    Shao, Dadong
    Mao, Xueli
    JOURNAL OF HAZARDOUS MATERIALS, 2018, 357 : 424 - 430
  • [32] Change of residual stresses and electrical properties of Pb(Zr, Ti)O3 thin films upon introducing various bottom electrodes
    Fujito, K
    Wakiya, N
    Shinozaki, K
    Mizutani, N
    JOURNAL OF THE CERAMIC SOCIETY OF JAPAN, 2002, 110 (05) : 421 - 427
  • [33] Evaluating microstructural and damage effects in rule-of-mixtures predictions of the mechanical properties of Ni-Al2O3 composites
    H. A. Bruck
    B. H. Rabin
    Journal of Materials Science, 1999, 34 : 2241 - 2251
  • [34] Preparation and properties of nano-SiC strengthening Al2O3 composite ceramics
    Shi, Xiaolei
    Dong, Yali
    Xu, Fumin
    Tan, Yi
    Wang, Lai
    Yang, Jenn-ming
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2011, 528 (06): : 2246 - 2249
  • [35] Effect of Grinding Process on Surface Quality and Mechanical Properties of Al2O3 Ceramics
    Liang J.
    Zhang X.
    Zhao G.
    Liu G.
    Shao H.
    Qiao G.
    Cailiao Daobao/Materials Reports, 2020, 34 (16): : 16020 - 16024
  • [36] An investigation on the properties of YSZ/Al2O3 nanocomposite coatings on Inconel by electrophoretic deposition
    Khanali, Omid
    Ariaee, Sina
    Rajabi, Masoud
    Baghshahi, Saeid
    JOURNAL OF COMPOSITE MATERIALS, 2018, 52 (01) : 81 - 89
  • [37] Preparation and properties of anti-reflective and anti-thermal shock of Y2O3 /AlN composite films on CVD diamond
    Pan, Xingchen
    Zhou, Bing
    Yu, Shengwang
    Piliptsou, D. G.
    Sun, Hui
    Liu, Zhubo
    CERAMICS INTERNATIONAL, 2024, 50 (13) : 23999 - 24007
  • [38] Mechanical properties and sliding wear behaviour of Al2O3-SiC nanocomposites with 3-20 vol% SiC
    Parchoviansky, M.
    Balko, J.
    Svancarek, P.
    Sedlacek, J.
    Dusza, J.
    Lofaj, F.
    Galusek, D.
    JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2017, 37 (14) : 4297 - 4306
  • [39] Effect of the Al2O3 content on the mechanical properties and microstructure of 3Y-TZP ceramics for dental applications
    Dongxu Tang
    Ki-Ju Lee
    Jingwen Xu
    Hyung-Bong Lim
    K. Park
    Won-Seung Cho
    Metals and Materials International, 2012, 18 : 545 - 551
  • [40] Effect of micro-alumina content on mechanical properties of Al2O3/3Y-TZP composites
    Zhang, Fan
    Li, Liang-feng
    Wang, En-ze
    CERAMICS INTERNATIONAL, 2015, 41 (09) : 12417 - 12425