Enhanced heat transfer in plate fin heat sink with dimples and protrusions

被引：0
作者：
Ayush Gupta
Manoj Kumar
Anil Kumar Patil
机构：
[1] DIT University,Department of Mechanical Engineering
来源：
Heat and Mass Transfer | 2019年 / 55卷
关键词：
D O I：
暂无
中图分类号：
学科分类号：
摘要：
The heat transfer and flow performance of the plate fin heat sink in a horizontal rectangular channel with dimples and protrusions on the fin surfaces has been experimentally investigated in forced convection. The Nusselt number and friction factor are obtained by varying the system parameters as depth and pitch of the dimples for inline and staggered arrangements. The Reynolds number is considered in the range of 6800 to 15,200. The effect of depth and pitch of dimples are examined under constant heat flux while keeping the constant diameter of dimples. Experimental results indicate that the heat transfer and flow performance of fin array are significantly influenced by increasing the depth of dimples. The heat transfer from fin array is enhanced and the flow resistance is increased by decreasing the pitch ratio (s/d) and increasing the depth ratio (D/d). The maximum fin performance of dimpled fin heat sink corresponds to the staggered arrangement of dimpled heat sink with dimple pitch ratio (s/d) of 2.5 and dimple depth ratio (D/d) of 0.5.
引用
收藏
页码：2247 / 2260
页数：13
相关论文
共 49 条
[1]  
Kim TY(2009)Fluid flow and heat transfer characteristics of cross-cut heat sinks Int J Heat Mass Transf 52 5358-5370
[2]  
Kim SJ(2010)An experimental investigation of air cooling thermal module using various enhancements at low Reynolds number region Int J Heat Mass Transf 53 5675-5681
[3]  
Yang KS(1986)Effect of tip-to-shroud clearance on turbulent heat transfer from a shrouded, longitudinal fin array ASME J Heat Transf 108 519-524
[4]  
Li SL(2009)Measurement of performance of plate-fin heat sinks with cross flow cooling Int J Heat Mass Transf 52 2949-2955
[5]  
Chen IY(2011)Effects of shield on thermal-fluid performance of vapour chamber heat sink Int J Heat Mass Transf 54 1410-1419
[6]  
Chien KH(2009)Effect of a shield on the hydraulic and thermal performance of a plate-fin heat sink Int Commun Heat Mass Transf 36 233-240
[7]  
Huc R(2013)Enhancing heat transfer in plate-fin heat sink using delta winglet vortex generators Int J Heat Mass Transf 67 666-677
[8]  
Wang CC(2007)Thermal performance of plate-fin heat sinks under confined impinging jet conditions Int J Heat Mass Transf 50 1963-1197
[9]  
Sparrow EM(2017)Conjugated heat transfer from a uniformly heated plate and a plate fin with uniform base heat flux Int J Heat Mass Transf 107 89-95
[10]  
Kadle DS(2015)Experimental and numerical evaluation of an elongated plate-fin heat sink with three sections of stepwise varying channel width Int J Heat Mass Transf 84 16-34
12345