Experimental investigation of a novel solar air heater based on heat pipe vacuum tube collector integrated with finned-tube heat exchanger

被引:0
作者
Anshul Sachdeva
M. Chandrashekara
Avadhesh Yadav
机构
[1] National Institute of Technology Kurukshetra,Department of Mechanical Engineering
[2] National Institute of Solar Energy,undefined
来源
Journal of Thermal Analysis and Calorimetry | 2023年 / 148卷
关键词
Solar air heater; Heat pipe vacuum tube; Header; Finned-tube heat exchanger; Sensible heat storage; Thermal analysis;
D O I
暂无
中图分类号
学科分类号
摘要
The study intends to analyze the thermal performance of a novel solar air heater based on heat pipe vacuum tube solar collector and finned-tube heat exchanger. The solar collector has been introduced with a new header where heat transfer fluid (Therminol-55) gains heat directly in contact with the condenser section of the heat pipe. This eliminates thermal paste application between the condenser and manifold in the existing systems. The system's thermal performance has been experimentally evaluated using two different (four-row and eight-row) finned-tube heat exchangers at four varied air flow rates, viz. 100 kg h–1, 400 kg h–1, 700 kg h–1 and 1000 kg h–1. The system with eight-row heat exchanger performed better than the four-row heat exchanger at each air flow rate. 100 kg h–1 resulted in a maximum rise in temperature of air (55.4 °C) and maximum outlet temperature of air (89.4 °C). Meanwhile, the maximum energy and exergy efficiency of 95.7% and 2.17% were observed at 1000 kg h–1. The maximum effectiveness of the four and eight-row heat exchangers was found as 70.7% and 79.4%, respectively, at 100 kg h–1. The monthly cost saving by utilization of the proposed system is 65.65 $, and the payback period is 12.4 months. The amount of CO2 averted from releasing into the atmosphere is 787.7 kg per month. The results suggest the utility of the proposed solar air heater as an environment-friendly replacement for conventional air heaters for consistent operation in the daytime. The experimental study was performed at the campus of NIT Kurukshetra, India (29.9476°N, 76.8155°E).
引用
收藏
页码:10917 / 10936
页数:19
相关论文
共 96 条
  • [11] Modi A(2019)Effect of using low-cost thermal insulation material in a solar air heating system with a shot blasted V-corrugated absorber plate Thermal Sci Eng Progr 14 35-211
  • [12] Almutairi K(2021)Exergetic and energetic evaluation of an innovative solar air heating system coated with graphene and copper oxide nano-particles J Thermal Eng 7 130-42
  • [13] Almutairi M(2012)Thermal performance of one-ended evacuated tube solar air collector at different flow rates: experimental investigation Int J Ambient Energy 33 199-374
  • [14] Harb K(2017)Experimental analysis of thermal performance of evacuated tube solar air collector with phase change material for sunshine and off-sunshine hours Int J Ambient Energy 38 828-67
  • [15] Marey O(2021)Performance analysis of a solar air heater modified with zig-zag shaped copper tubes using energy-exergy methodology Sustain Energy Technol Assess 46 365-32
  • [16] Aungkulanon P(2019)Coupling of a parabolic solar dish collector to finned-tube heat exchangers for hot air production: an experimental and theoretical study Solar Energy 187 1649-85
  • [17] Türk Toǧrul I(2021)A novel thermal storage integrated evacuated tube heat pipe solar air heater: energy, exergy, economic and environmental impact analysis Solar Energy 220 7202-48
  • [18] Pehlivan D(2022)Experimental study on heat storage integrated flat plate solar collector for combined water and air heating in buildings Appl Therm Eng 216 6868-82
  • [19] Tanda G(2020)Design and experimental investigation of a phase change energy storage air-type solar heat pump heating system Appl Therm Eng 179 7333-75
  • [20] Türk Togrul I(2021)Investigation of flow pattern, thermohydraulic performance and heat transfer improvement in 3D corrugated circular pipe under varying structure configuration parameters with development different correlations Int Commun Heat Mass Transfer 126 12253-713