Development of high productivity liquid centrifugal separator drives

被引：0

作者：

Dekhanov V.I. ^{[1
]}

Ratynskaya N.A. ^{[1
]}

机构：

[1] Moscow State University of Mechanical Engineering (MAMI), Moscow

来源：

Chemical and Petroleum Engineering | 2013年 / 49卷 / 3-4期

关键词：

Flow Through Channel; Screw Thread; Vertical Shaft; Rotor Diameter; Lubrication System;

D O I：

10.1007/s10556-013-9719-3

中图分类号：

学科分类号：

摘要：

The problem is considered of developing high productivity liquid centrifugal separator drives, and, in fact, establishment of application fields for screw involute gear and belt transmissions in liquid centrifugal separator drives. It is established on the basis of research that in separators with a rotor diameter not more than 500 mm with a sufficient degree of reliability it is possible to use a drive with an involute screw gear. For high productivity separators with a rotor diameter more than 500 mm, it is desirable to use a drive with a belt transmission. The problem of vertical shaft bearing lubrication is also resolved with the use of a belt transmission drive. A lubrication system is constructed providing oil supply to bearing supports with a low vertical shaft rotation rate. © 2013 Springer Science+Business Media New York.

引用

页码：162 / 166

页数：4

共 6 条

[1]

Litvin F.L., Gearing Theory [in Russian], (1968)

[2]

Remezova N.E., Design of screw gears for jamming, Vestn. Mashinostr., 4, pp. 28-29, (1960)

[3]

Dekhanov V.I., Study of gear transmission for centrifugal separators UDV-602-K2, Khim. Neftegaz. Mashinostr., 3, pp. 12-13, (1973)

[4]

Dekhanov V.I., Ratynskaya N.A., Operating safety provision for centrifugal separators by reducing dynamic reactions in rotor supports, Khim. Neftegaz. Mashinostr., 2, pp. 36-40, (2011)

[5]

Dekhanov V.I., Experimental study of centrifugal separator-thickener operation with a direct drive, Khim. Neftegaz. Mashinostr., 3, pp. 11-12, (1979)

[6]

Kantorovich Z.B., Chemical Industry Machines [in Russian], (1965)

← 1 →