Cut-layer cross section in oblique turning by a single-edge tool with a curved rear surface

被引：6
作者：
Filippov A.V. [1 ]
机构：
[1] Yurga Technological Institute, Tomsk Polytechnic University, Yurga
来源：
Russian Engineering Research | 2015年 / 35卷 / 5期
关键词：
curved rear surface; cut-layer cross section; cutting surface; oblique turning; single-edge tool;
D O I：
10.3103/S1068798X15050135
中图分类号：
学科分类号：
摘要：
A method is proposed for determining the parameters of the cut-layer cross section in oblique turning by a single-edge tool with a curved rear surface. The results are plotted as a function of the supply, the cutting depth, the cutter inclination, and the curvature of the rear surface. © 2015, Allerton Press, Inc.
引用
收藏
页码：385 / 388
页数：3
相关论文
共 17 条
  • [1] Bobrov V.F., Vliyanie ugla naklony glavnoi rezhushchei kromki instrumenta na protsess rezaniya metallo, (1962)
  • [2] Bobrov V.F., Ierusalimov D.E., Rezanie metallov Samovrashchayushchimisya reztsam, (1972)
  • [3] Galoyan G.P., Theoretical Principles of a New Diagonal Turning Proces, (1986)
  • [4] Granovskii G.I., Granovskii V.G., Rezanie metallo, (1985)
  • [5] Efimov K.V., Kratkii kurs analiticheskoi geometri, (1969)
  • [6] Klimenko S.A., Manokhin A.S., Hard turning of shaving type, Sverkhtverd. Mater, pp. 58-74, (2009)
  • [7] Konovalov E.G., Sidorenko V.A., Sous' A.V., Progressivnye skhemy rotatsionnogo rezaniya metallo, (1972)
  • [8] Minasyan G.S., Surface roughness in turning by a BRM-1 single-edge tool, Izv. Akad. Nauk ASS, 23, 4, pp. 3-6, (1970)
  • [9] Petrushin S.I., Filippov A.V., Analysis of the geometry of oblique sharpening of single-edge tools, Obrab. Met., Tekhnol., Oborud., Instrum, pp. 8-14, (2013)
  • [10] Podgorkov V.V., Final turning by single-edge tools, Stanki Instrum, pp. 30-31, (1974)
12