Collaborative Position Control of Pantograph Robot Using Particle Swarm Optimization

被引:0
作者
Nihad Ali
Yasar Ayaz
Jamshed Iqbal
机构
[1] National University of Science and Technology,Department of Robotics and Intelligent Machine Engineering
[2] Shanghai Jiao Tong University,Department of Automation
[3] University of Hull,Department of Computer Science and Technology, Faculty of Science and Engineering
来源
International Journal of Control, Automation and Systems | 2022年 / 20卷
关键词
Optimal control; pantograph; particle swarm optimization; robotics; rotary servo; tracking;
D O I
暂无
中图分类号
学科分类号
摘要
This article presents the design and real-time implementation of an optimal collaborative approach to obtain the desired trajectory tracking of two Degree of Freedom (DOF) pantograph end effector position. The proposed controller constructively synergizes the Proportional Integral Derivative (PID) and Linear Quadratic Regulator (LQR) by taking their weighted sum. Particle Swarm Optimization (PSO) algorithm is proposed to optimally tune the gains of PID, weighting matrices of LQR, and their ratio of contributions. Initially, the PID and LQR controller parameters are optimally tuned using PSO. In order to enhance the control effort and to provide more optimal performance, the weightages of each controller are optimally tuned and are kept constant. The collaborative position control strategy is tested against the PID and the LQR controllers via hardware in loop trials on a robotic manipulator. Experimental results are provided to validate the accurate trajectory tracking of the proposed controller. Results demonstrate that the optimal combination renders a significant improvement of 10% in steady-state response and about 37% in transient response over the PID and LQR schemes.
引用
收藏
页码:198 / 207
页数:9
相关论文
共 95 条
[1]  
Iqbal J(2016)Automating industrial tasks through mechatronic systems a review of robotics in industrial perspective Tehnički vjesnik 23 917-924
[2]  
Islam R U(2019)Adaptive robust nonsingular terminal sliding mode design controller for quadrotor aerial manipulator Telkomnika 17 1501-1512
[3]  
Abbas S Z(2019)A SLIP-based robot leg for decoupled spring-like behavior: Design and evaluation International Journal of Control, Automation and Systems 17 2388-2399
[4]  
Khan A A(2017)Nonlinear control systems — A brief overview of historical and recent advances Nonlinear Engineering 6 301-312
[5]  
Ajwad S A(2019)Modern control laws for an articulated robotic arm: Modeling and simulation Engineering, Technology & Applied Science Research 9 4057-4061
[6]  
Samah R(2019)Adaptive backstepping based sensor and actuator fault tolerant control of a manipulator Journal of Electrical Engineering and Technology 14 2497-2504
[7]  
Kidouche M(2019)Robust sliding mode control for flexible joint robotic manipulator via disturbance observer Description of Complex Systems: INDECS 17 85-97
[8]  
Rezoug A(2017)On the derivation of novel model and sophisticated control of flexible joint manipulator Revue Roumaine des Sciences Techniques-Serie Electrotechnique et Energetique 62 103-108
[9]  
Seo J(2019)Experimental validation of an integral sliding mode-based LQG for the pitch control of a UAV-mimicking platform Advances in Electrical and Electronics Engineering 17 275-284
[10]  
Kim J(2018)Optimal and robust control of multi DOF robotic manipulator: Design and hardware realization Cybernetics and Systems 49 77-93