Doping TiO2 with Fe from iron rusty waste for enhancing its activity under visible light in the Congo red dye photodegradation

被引：2

作者：

Wahyuni E.T. ^{[1
]}

Lestari N.D. ^{[1
]}

Cinjana I.R. ^{[1
]}

Annur S. ^{[1
]}

Natsir T.A. ^{[1
]}

Mudasir M. ^{[1
]}

机构：

[1] Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Yogyakarta

来源：

Journal of Engineering and Applied Science | 2023年 / 70卷 / 01期

关键词：

Congo red; Doping; Fe; Photodegradation; Rusted iron waste; TiO[!sub]2[!/sub;

D O I：

10.1186/s44147-023-00178-9

中图分类号：

学科分类号：

摘要：

An afford to enhance TiO2 activity under visible light as well as to utilize the iron rusty waste, has been conducted by doping Fe from the waste into TiO2. The doping was performed by sol-gel method of titania tetra isopropoxide with Fe3+ ions dissolved from the iron rust waste. In the doping, the concentration of Fe3+ was varied giving various mole ratios of TiO2:Fe. The doped TiO2 photocatalysts were characterized using FTIR, XRD, SRUV, and SEM-EDX instruments. The photocatalytic activity of the doped TiO2 was evaluated by photodegradation of Congo red under visible light. The effect of some parameters that govern the photodegradation process such as the amount of Fe dopant, reaction time, photocatalyst mass, solution pH, and initial concentration of dye was also studied. The characterization results reveal that Fe3+ ions from the rusty waste have been doped into TiO2 which can remarkably narrow the band gap energy (Eg), shifting into the visible zone. In accordance, the activity of TiO2 under visible light in the dye photodegradation is considerably enhanced. The Eg decreasing and actively improving the doped TiO2 are controlled by the amount of Fe dopant, and the most effective Eg decreasing is shown by TiO2–Fe (1:0.8), but the highest activity is observed for TiO2–Fe (1:0.4). It is also found that the highest photodegradation of Congo red 5 mg/L in 50 mL of the solution over TiO2–Fe (1:0.4) under visible light, that is about 99%, can be reached by applying 60 mg of the photocatalyst mass, in 60 min, and solution pH 5. It is implied that the rusty waste can be utilized to prepare the visible responsive photocatalyst that can be used for preventing dye pollution. © 2023, The Author(s).

引用

共 25 条

[1]

Amini M., Ashrafi M., Photocatalytic degradation of some organic dyes under solar light irradiation using TiO2 and ZnO nanoparticles, Nano Res, 1, pp. 79-86, (2016)

[2]

Zhu X., Zhou D., Cang L., Wang Y., TiO2 photocatalytic degradation of 4-chlorobiphenyl as affected by solvents and surfactants, J Soils Sediments, 12, pp. 376-385, (2012)

[3]

Dalida M.L.P., Amer K.M.S., Su C.C., Lu M.C., Photocatalytic degradation of acetaminophen in modified TiO2 under visible irradiation, Environ Sci Pollut Res, 21, pp. 1208-1216, (2014)

[4]

Wu S., Hu H., Lin Y., Et al., Visible light photocatalytic degradation of tetracycline over TiO2, Chem Eng J, 382, (2020)

[5]

Ben Jemaa I., Chaabouni F., Ranguis A., Cr doping effect on the structural, optoelectrical and photocatalytic properties of RF sputtered TiO2 thin films from a powder target, J Alloys Compd, 825, (2020)

[6]

Li X., Guo Z., He T., The doping mechanism of Cr into TiO 2 and its influence on the photocatalytic performance, Phys Chem, 15, pp. 20037-20045, (2013)

[7]

Kaur R., Singla P., Singh K., Transition metals (Mn, Ni, co) doping in TiO2 nanoparticles and their effect on degradation of diethyl phthalate, Int J Environ Sci Technol, 15, pp. 2359-2368, (2018)

[8]

Lee H., Jang H.S., Kim N.Y., Joo J.B., Cu-doped TiO2 hollow nanostructures for the enhanced photocatalysis under visible light conditions, J Ind Eng Chem, 99, pp. 352-363, (2021)

[9]

Crisan M., Dragan N., Crisan D., Et al., The effects of Fe, co and Ni dopants on TiO2 structure of sol–gel nanopowders used as photocatalysts for environmental protection: a comparative study, Ceram Int, 42, pp. 3088-3095, (2016)

[10]

Khoshnevisan B., Marami M.B., Farahmandjou M., Fe3+-doped Anatase TiO2 study prepared by new sol-gel precursors, Chin Phys Lett, 35, pp. 27501-27505, (2018)

← 1 2 3 →