Laser Cladding to Improve Oxidation Behavior of Air Plasma-Sprayed Ni-20Cr Coating on Stainless Steel Substrate

被引:0
作者
M. Mudassar Rauf
Muhammad Shahid
A. Nusair Khan
K. Mehmood
机构
[1] National University of Sciences & Technology,School of Chemical and Material Engineering
[2] Institute of Industrial and Control System,undefined
来源
Journal of Materials Engineering and Performance | 2015年 / 24卷
关键词
laser; Ni-20Cr; oxidation; plasma;
D O I
暂无
中图分类号
学科分类号
摘要
Air plasma-sprayed Ni-20Cr coating on stainless steel (AISI-304) substrate was re-melted using CO2 laser to remove the inherent defects, i.e., porosity, splat boundaries, and oxides of air plasma-sprayed coating. The (1) uncoated, (2) air plasma-sprayed, and (3) laser-re-melted specimens were exposed to cyclic oxidation at 900 °C for a hundred cycles run. The oxidation products were characterized using XRD and SEM. Weight changes were determined after every 4th cycle; Uncoated samples showed severe oxidation indicated by substantial weight loss, whereas air plasma-coated samples demonstrated noticeable weight gain. However, oxidation resistance of laser-cladded samples was found to be significantly improved as the samples showed negligible weight change; porosity within the coating was minimized with an improvement in interface quality causing reduction in delamination damage.
引用
收藏
页码:3651 / 3657
页数:6
相关论文
共 64 条
[11]  
Khan AN(1996)O Mater. Transa. JIM 37 991-997
[12]  
Stein KJ(1997)-13wt% TiO Mater. Sci. Technol. 13 56-60
[13]  
Schorr BS(1998) Coatings on Al–Si Alloy Influenced by Laser Remelting Wear 214 30-37
[14]  
Marder AR(1990)Evaluation of High Temperature Corrosion Resistance of Al Plasma Spray Coatings in Molten Sulfates at 1073 K by Electrochemical Measurements Mater. Sci. Lett. 25 445-454
[15]  
Kumar M(1991)Corrosion Behaviour of Laser Melted Plasma Sprayed Coatings on 12% Chromium Dual Phase Steel Surf. Coat. Technol. 45 449-456
[16]  
Sing H(2007)Cohesion in Plasma-Sprayed Coatings: A Comparison Between Evaluation Methods Trans. JWRI 36 41-45
[17]  
Singh N(2000)Development of Microstructure in Laser Surface Alloying of Steel with Chromium Surf. Coat. Technol. 124 1-12
[18]  
Kawahara Y(2004)Corrosion Resistance of Fe–Ni–Cr Laser Surface Alloys Mater. Sci. Technol. 20 81-84
[19]  
Singh H(2009)Bond Coat Oxidation and Hot Corrosion Behavior of Plasma Sprayed YSZ Coating on Ni Superalloy Appl. Surf. Sci. 255 6862-6869
[20]  
Puri D(undefined)Phase Transformation and Bond Coat Oxidation Behavior of Plasma Sprayed Zirconia Thermal Barrier Coating undefined undefined undefined-undefined