Post-processor development of a hybrid TRR-XY parallel kinematic machine tool

被引：16
作者：
Chen S.-L. [2 ]
Chang T.-H. [1 ]
Inasaki I. [3 ]
Liu Y.-C. [2 ]
机构：
[1] Department of Mechanical Engineering, Keio University
[2] Institute of Manufacturing Engineering, National Cheng-Kung University
[3] Faculty of Science and Technology, Keio University
来源：
The International Journal of Advanced Manufacturing Technology | 2002年 / 20卷 / 4期
关键词：
Machine tool; NC; Parallel kinematic; Post-processor;
D O I：
10.1007/s001700200151
中图分类号：
学科分类号：
摘要：
A hybrid 5-degrees-of-freedom parallel kinematic machine tool constructed using the TRR-XY mechanism has been used to investigate the theory of post-processing. The effects of the cutter shapes and machine construction on the post-processing are investigated. Some specific parameters only are required to modify the post-processing for the different tools used in real cutting. The tilt angle and yaw angle of the cutter relative to the normal direction of the cutting surface are included in the investigation. The parametric representations of different cutter shapes defined by the DIN standard were also adopted in the derivation. The generality of the post-processor theory developed was then increased. Finally, NC code has been generated using LABVIEW software. Simulations are performed to verify the correctness of the work based on several designed tool paths.
引用
收藏
页码：259 / 269
页数：10
相关论文
共 11 条
  • [1] Stewart D., A platform with six degrees of freedom, Proceedings of the Institution of Mechanical Engineering (London), 180, 15 PART 1, pp. 371-386, (1965)
  • [2] Honegger M., Codourey A., Burdet E., Adaptive control of the hexaglide, a 6 DOF parallel manipulator, Proceeding of the 1997 IEEE, International Conference on Robotics and Automation, pp. 543-548, (1997)
  • [3] Micromat
  • [4] Bedi S., Vickers G.W., Postprocessor for numerically controlled machine tools, Computers in Industry, 9, 1, pp. 3-18, (1987)
  • [5] Suh S.H., Lee K.S., A prototype CAM systems for four-Axis NC machine of rotational-free-surface, Journal of Manufacturing System, 10, 4, pp. 322-331, (1991)
  • [6] Takeuchi Y., Watanabe T., Generation of 5-axis control collision-free tool path and post-processing for NC data, Annals CIRP, 41, 1, pp. 539-542, (1992)
  • [7] Hunt K.H., Kinematic Geometry of Mechanisms, pp. 304-309, (1978)
  • [8] Lee K.M., Shah D.K., Kinematic analysis of a three-degrees-of-freedom in-parallel actuated manipulator, IEEE Journal of Robotics and Automation, 4, 3, pp. 354-367, (1988)
  • [9] Zeid I., CAD/CAM Theory and Practice, (1991)
  • [10] Piegl L., Tiller W., The NURBS Book, 2nd edn, (1997)
12