Measurement of the Strong Pressure Appearance Laws with Hard Roof and Full Mechanized Mining Extra Thick Coal Seam

被引:4
|
作者
Wang Z. [1 ,2 ]
Guo X. [1 ,2 ]
Wang C. [1 ,2 ]
机构
[1] Tunnel and Underground Structure Engineering Center of Liaoning, Dalian Jiaotong University, Dalian
[2] School of Civil and Safety Engineering, Dalian Jiaotong University, Dalian
基金
中国国家自然科学基金;
关键词
Abutment pressure; Extra-thick coal seam; Measurement; Strong pressure appearance; Work resistance;
D O I
10.1007/s10706-018-0541-8
中图分类号
学科分类号
摘要
To master the laws of strong strata behavior of Tashan coal mine under Carboniferous coal mining process, the laws of strong strata behavior in 8107 working face was measured and analyzed. It was shown that the average initial weighting step of 8107 working face was 59.4 m. The average periodic weighting step of main roof was 16.2 m. The maximum working resistance during periodic weighting was 14,711.1 kN. The maximum working resistance during non-periodic weighting was 11,339.9 kN. The average dynamic load factor K during periodic weighting was 1.31. The stress of coal column on the side of the goaf could be divided into four zones (stress stabilization zone, stress slow-increasing zone, significant—increasing stress zone, stress reduction zone) along the strike of 8107 working face. There was a peak of lateral support pressure along the trend of 8107 working face. And the peak position was biased to the side of return airway roadway. With the increase of the distance from the down-side of return airway, the pressure peak of the inner coal body along the strike of 8107 the working face increased and the peak position decreased from the coal wall. The peak stress of coal column tended to be close to the up-side of return airway. And the distance from the down-side of return airway for the peak of inner coal was larger than that for the peak of coal pillar. The peak position of abutment pressure of hard roof was in the range of 10–25 m in front of 8107 working face under full mechanized mining extra thickness coal seam conditions. The relative stress concentration coefficient of k was 1.3–6.5. The range of 10–25 m from the front of the working face to coal wall was stress reduction zone. And the influence range of abutment pressure was about 80 m. It was of great significance to the control and practice of the surrounding rock of the stope for the mining of the hard extra-thick coal seam. © 2018, Springer International Publishing AG, part of Springer Nature.
引用
收藏
页码:3399 / 3409
页数:10
相关论文
共 50 条
  • [41] Effects of Different Factors on the Mining of Extra-Thick Coal Seam
    Liu, Naifei
    Zhang, Zhu
    Li, Ning
    Yang, Min
    Ren, Yuanyang
    PROCEEDINGS OF GEOSHANGHAI 2018 INTERNATIONAL CONFERENCE: TUNNELLING AND UNDERGROUND CONSTRUCTION, 2018, : 40 - 53
  • [42] Study on failure characteristics of overburden in extra thick coal seam mining
    Chang Liu
    Pingsong Zhang
    Duoxi Yao
    Yuanchao Ou
    Yutong Tian
    Environmental Earth Sciences, 2022, 81
  • [43] Study on Laws of Mine Pressure Appearance at Blasting Caving Coal Face of "Three Soft" Unstable Thick Coal Seam
    Sun Guangzhong
    Jing Yongbin
    Guo Junjie
    Wang Guoji
    PROCEEDINGS OF THE 4TH INTERNATIONAL SYMPOSIUM ON MINE SAFETY (2012), 2012, : 511 - 514
  • [44] Analysis of the Influence Characteristics of the Support Stability of a Fully Mechanized Coal Mining Face under the Hard Roof Mining Pressure
    Dang, Jiaxin
    Tu, Min
    Zhang, Xiangyang
    Bu, Qingwei
    SHOCK AND VIBRATION, 2021, 2021
  • [45] Mining-Induced Stress and Ground Pressure Behavior Characteristics in Mining a Thick Coal Seam With Hard Roofs
    Zhu, Zhijie
    Wu, Yunlong
    Liang, Zhuang
    FRONTIERS IN EARTH SCIENCE, 2022, 10
  • [46] Overburden failure and fissure development characteristics of deep buried extra thick coal seam and fully-mechanized caving mining
    School of Energy Science and Engineering, Henan Polytechnic University, Jiaozuo
    454000, China
    不详
    155100, China
    Dongbei Daxue Xuebao, (10-15):
  • [47] Study of dynamic pressure mechanism and laws of fully mechanized sub-level caving in extremely thick coal seam
    Zhou, Ying
    Nan, Hua
    Li, Hua-Min
    Dai, Yong-Hao
    Meitan Xuebao/Journal of the China Coal Society, 2004, 29 (04):
  • [48] The Mechanism and Control Technology of Strong Strata Behavior in Extra-Thick Coal Seam Mining Influenced by Overlying Coal Pillar
    Gao, Rui
    Kuang, Tiejun
    Lan, Yiwen
    OPEN GEOSCIENCES, 2019, 11 (01) : 452 - 461
  • [49] Control of Weighting Accident and Its New Monitoring and Forecast for Mining Coal Seam with Hard Roof of Thick Layer Sandstone
    Zhao, Tongbin
    Chen, Yunjuan
    Tan, Yunliang
    Zhang, Ze
    PROCEEDINGS OF 2009 INTERNATIONAL SYMPOSIUM ON RISK CONTROL AND MANAGEMENT OF DESIGN, CONSTRUCTION AND OPERATION IN UNDERGROUND ENGINEERING, 2009, : 265 - 270
  • [50] Ground control of narrow coal pillar in gob side entry driving with fully mechanized top coal caving mining in extra-thick coal seam
    Dong, Hexiang
    Journal of Mining and Strata Control Engineering, 2021, 3 (03):