Diagnostics of cut-layer deformation and rational tool loading in numerically controlled lathes

被引：6

作者：

Nekrasov R.Y. ^{[1
]}

Putilova U.S. ^{[1
]}

Nekrasov Y.I. ^{[1
]}

Starikov A.I. ^{[1
]}

Kharitonov D.A. ^{[1
]}

机构：

[1] Tyumen State Oil and Gas University, Tyumen

来源：

Russian Engineering Research | 2014年 / 34卷 / 12期

关键词：

contact-load stabilization; cut-layer deformation; cutting thermoemf;

D O I：

10.3103/S1068798X14120181

中图分类号：

学科分类号：

摘要：

Reliability is a particular concern in turning high-strength steel and alloys on numerically controlled lathes, since even small changes in the factors present significantly alter the cutting process and the tool’s wear rate in the case of strict programmatic control. © 2014, Allerton Press, Inc.

引用

页码：826 / 828

页数：2

共 4 条

[1] Deformation and failure in adjusting the cut-layer thickness
Postnov V.V.
Sukhanova N.N.
Russian Engineering Research, 2014, 34 (01) : 46 - 48
[2] Cut-layer cross section in oblique turning by a single-edge tool with a curved front surface
Filippov A.V.
Russian Engineering Research, 2015, 35 (5) : 381 - 384
[3] Cut-layer cross section in oblique turning by a single-edge tool with a curved rear surface
Filippov A.V.
Russian Engineering Research, 2015, 35 (5) : 385 - 388
[4] 3-DIMENSIONAL NUMERICALLY CONTROLLED CONTOURING BY ELECTRIC-DISCHARGE MACHINING WITH COMPENSATION FOR THE DEFORMATION OF CYLINDRICAL TOOL ELECTRODES
KANEKO, T
TSUCHIYA, M
PRECISION ENGINEERING-JOURNAL OF THE AMERICAN SOCIETY FOR PRECISION ENGINEERING, 1988, 10 (03): : 157 - 163

← 1 →