Study on the mechanical behavior of adhesive interface by digital image correlation

被引：0
作者：
BaoQiao Guo
HuiMin Xie
JianGuo Zhu
HuaiXi Wang
PengWan Chen
QingMing Zhang
机构：
[1] Tsinghua University,Key Laboratory of Applied Mechanics, Department of Engineering Mechanics
[2] Beijing Institute of Technology,State Key Laboratory of Explosion Science and Technology
来源：
Science China Physics, Mechanics and Astronomy | 2011年 / 54卷
关键词：
single lap joint; shear modulus; adhesive interface; failure; digital image correlation;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
The shear modulus of the adhesive layer and the failure mode of adhesive structure on single lap joint specimens under tensile tests are investigated in this paper. The aluminum-aluminum adherends are bonded by two different adhesives: polydimethylsiloxane (PDMS) and epoxy. The full deformation fields are measured using the digital image correlation (DIC) method with the images on the middle part of the adhesive layer recorded by a high resolution microscope. Then, the shear modulus values of the two adhesives are calculated with a simple pure shear strain model. A numerical model is proposed to simulate the single lap joint structure under tensile load in comparison with the experimental results. The results show that this method can successfully estimate the shear modulus of the adhesive layer. The failure behavior of epoxy adhesive/adherend interface is also analyzed and discussed.
引用
收藏
页码：574 / 580
页数：6
相关论文
共 46 条
[1]  
Owens J.(2000)Stiffness behaviour due to fracture in adhesively bonded composite-to-aluminum joints I Theoretical model. Int J Adhes Adhes 20 39-45
[2]  
Lee-Sullivan P.(2000)Stiffness behaviour due to fracture in adhesively bonded composite-to-aluminum joints II Experimental. Int J Adhes Adhes 20 47-58
[3]  
Owens J.(2009)Analytical models of adhesively bonded joints—Part I: Literature survey Int J Adhes Adhes 29 319-330
[4]  
Lee-Sullivan P.(2009)Analytical models of adhesively bonded joints—Part II: Comparative study Int J Adhes Adhes 29 331-341
[5]  
da Silva L.(2001)Finite element and experimental studies on singlelap balanced joints in tension Int J Adhes Adhes 21 211-220
[6]  
das Neves P.(2007)Experimental and numerical investigation of mechanical and thermal residual strains in adhesively bonded joints Strain 43 319-331
[7]  
Adams R.(2011)Experimental and numerical investigation of strain distributions within the adhesive layer in bonded joints Strain 47 84-104
[8]  
da Silva L.(2010)Shear modulus estimation of the polymer polydimethylsiloxane (PDMS) using digital image correlation Mater Des 31 583-588
[9]  
das Neves P.(2007)Development of patterns for digital image correlation measurements at reduced length scales Exp Mech 47 63-77
[10]  
Adams R.(2006)Metrology in a scanning electron microscope: Theoretical developments and experimental validation Meas Sci Technol 17 2613-2622
12345