Experimental study on heat transfer of thermally developing and developed, turbulent, horizontal pipe flow of dilute air-solids suspensions

被引：0

作者：

T. Aihara

K. Yamamoto

K. Narusawa

T. Haraguchi

M. Ukaku

A. Lasek

F. Feuillebois

机构：

[1] Institute of Fluid Science,

[2] Tohoku University 2-1-1 Katahira,undefined

[3] Aoba-ku,undefined

[4] Sendai 980-77,undefined

[5] Japan,undefined

[6] Component and Dynamics Dept 2 Engine Engineering Div 1,undefined

[7] Toyota Motor Corp. 1 Toyota-cho,undefined

[8] Toyota 471,undefined

[9] Japan,undefined

[10] Engine Sect,undefined

[11] Traffic Nuisance Div,undefined

[12] Traffic Safety and Nuisance Research Institute 6-38-1 Shinkawa,undefined

[13] Mitaka,undefined

[14] Tokyo 181,undefined

[15] Japan,undefined

[16] Department of System Engineering,undefined

[17] Faculty of Engineering,undefined

[18] Ibaraki University 4-12-1 Naka Narusawa-cho,undefined

[19] Hitachi 316,undefined

[20] Japan,undefined

[21] Laboratoire d'Aerothermique,undefined

[22] CNRS 4 ter,undefined

[23] route des Gardes,undefined

[24] F-92190 Meudon,undefined

[25] France,undefined

[26] Laboratoire de Physique et Mecanique des Materiaux Heterogenes,undefined

[27] CNRS Ecole Superieure de Physique et Chemie Industrielles 10,undefined

[28] rue Vauquelin,undefined

[29] F-75231 Paris,undefined

[30] Cedex 05,undefined

[31] France,undefined

来源：

Heat and Mass Transfer | 1997年 / 33卷

关键词：

Heat Transfer; Experimental Study; Reynolds Number; Glass Bead; Mass Flux;

D O I：

暂无

中图分类号：

学科分类号：

摘要：

Heat transfer characteristics of a turbulent, dilute air-solids suspension flow in thermally developing/developed regions were experimentally studied, using a uniformly heated, horizontal 54.5 mm-ID pipe and 43-μm-diameter glass beads. The local heat transfer was measured at 27 locations from the inlet to 120-dia downstream of the heated section over a range of Reynolds numbers 3×104−1.2×105 and solids loading ratio 0–3, and the fully developed profiles of air velocity/temperature and particle mass flux were measured at a location 140-dia downstream of the heated section using specially designed probes, inserted into the suspension flow. The effects of the Reynolds number, solids loading ratio, and azimuthal/longitudinal locations on the heat transfer characteristics and their interactions are discussed through comparison of the present results with the data obtained by other investigators.

引用

页码：109 / 120

页数：11