Selecting the process arrangement for preparing the gas turbine working fluid for an integrated gasification combined-cycle power plant

被引：8

作者：

Ryzhkov A.F. ^{[1
]}

Gordeev S.I. ^{[1
]}

Bogatova T.F. ^{[1
]}

机构：

[1] Ural Federal University, ul. Mira 19, Yekaterinburg

来源：

Thermal Engineering | 2015年 / 62卷 / 11期

基金：

俄罗斯科学基金会;

关键词：

air separation unit; chemical equilibrium; gasification plant; integrated gasification combined-cycle power plant; oxygen and air gasification; working fluid preparation system;

D O I：

10.1134/S0040601515110075

中图分类号：

学科分类号：

摘要：

Introduction of a combined-cycle technology based on fuel gasification integrated in the process cycle (commonly known as integrated gasification combined cycle technology) is among avenues of development activities aimed at achieving more efficient operation of coal-fired power units at thermal power plants. The introduction of this technology is presently facing the following difficulties: IGCC installations are characterized by high capital intensity, low energy efficiency, and insufficient reliability and availability indicators. It was revealed from an analysis of literature sources that these drawbacks are typical for the gas turbine working fluid preparation system, the main component of which is a gasification plant. Different methods for improving the gasification plant chemical efficiency were compared, including blast air high-temperature heating, use of industrial oxygen, and a combination of these two methods implying limited use of oxygen and moderate heating of blast air. Calculated investigations aimed at estimating the influence of methods for achieving more efficient air gasification are carried out taking as an example the gasifier produced by the Mitsubishi Heavy Industries (MHI) with a thermal capacity of 500 MW. The investigation procedure was verified against the known experimental data. Modes have been determined in which the use of high-temperature heating of blast air for gasification and cycle air upstream of the gas turbine combustion chamber makes it possible to increase the working fluid preparation system efficiency to a level exceeding the efficiency of the oxygen process performed according to the Shell technology. For the gasification plant’s configuration and the GTU working fluid preparation system be selected on a well-grounded basis, this work should be supplemented with technical-economic calculations. © 2015, Pleiades Publishing, Inc.

引用

页码：796 / 801

页数：5

共 11 条

[1]

Tugov A.N., Prospects for the use of municipal solid wastes as secondary energy resources in Russia, Therm. Eng., 60, 9, (2013)

[2]

Keiko A.V., Svishchev D.A., A thermodynamic analysis of operating conditions under which coal–water fuel is gasified in flow, Therm. Eng., 57, 6, (2010)

[3]

Ol'khovskii G.G., Suchkov S.I., Berezinets P.A., Epikhin A.N., Krylov I.O., Lugovskaya I.G., Somov A.A., Gudkov V.N., Zaikin A.A., Development of a domestic combined cycle plant with coal gasification, Therm. Eng., 57, 2, (2010)

[4]

Monastyreva T.N., Technical–economic assessment of the effect from putting coal gasification technologies in use at thermal power plants, Sovrem. Nauka, 3, 8, pp. 99-102, (2011)

[5]

Hashimoto T., Sakamoto K., Kitagawa Y., Hyakutake Y., Setani N., Development of IGCC commercial plant with air-blown gasifier, Mitsubishi Heavy Industries Technical Review, 46, 2, pp. 1-5, (2009)

[6]

Uchida S., Shinada O., Furuya T., Feasibility and status of coal gasification combined plant in Japan, ACS Division of Fuel Chemistry Preprints, pp. 516-520, (1996)

[7]

Giuffrida A., Romano M.C., Lozza G., Thermodynamic analysis of air-blown gasification for IGCC applications, Applied Energy, 88, 11, pp. 3949-3958, (2011)

[8]

Smith W.R., Wissen R.W., Chemical Reaction Equilibrium Analysis: Theory and Algorithms, (1991)

[9]

M. Eurlings J.T.G., Ploeg J.E.G., Process performance of the SCGP at Buggennum IGCC, Proceedings of the Gasification Technologies Conference, (1999)

[10]

Bogatova T.F., Ryzhkov A.F., Val'tsev N.V., Osipov P.V., Gordeev S.I., Hybrid coal-fired combinedcycle plants, Energetik, 12, pp. 12-16, (2014)

← 1 2 →