Dependence of photoluminescence on sulfurization temperature of Cu2SnS3 thin films

被引:0
|
作者
Kunihiko Tanaka
Shogo Miyagi
Daiki Motai
Ryota Ohashi
Yoko Hosokawa
Kazuo Jimbo
Yoji Akaki
Hideaki Araki
机构
[1] Nagaoka University of Technology,Department of Electrical, Electronics and Information Engineering
[2] Nagaoka College,National Institute of Technology (KOSEN)
[3] Miyakonojo College,National Institute of Technology (KOSEN)
来源
Applied Physics A | 2023年 / 129卷
关键词
Cu; SnS; Photoluminescence; Thin film solar cell; Exciton luminescence; Donor–acceptor pair (DAP) recombination luminescence; Crystal structure;
D O I
暂无
中图分类号
学科分类号
摘要
The dependence of photoluminescence (PL) on sulfurization temperature of the Cu2SnS3 (CTS) thin films was investigated. CTS thin films were prepared at various sulfurization temperatures in the range of 500–600 ℃, and differences in the conversion efficiency of solar cells with the CTS thin films as absorption layer and the crystal structure of the CTS thin films were observed. In low-conversion-efficiency CTS films, which were a mix of monoclinic and cubic crystals, the PL spectrum only showed donor–acceptor pair (DAP) recombination luminescence due to deep defects. In high-conversion-efficiency CTS thin films, which contained only monoclinic crystals, the PL spectrum showed DAP recombination luminescence originating from the same deep defects. In addition band-edge luminescence was observed at room temperature. Thus, it was found that the conversion efficiency and crystal structure of CTS thin film can be easily estimated from PL measurements.
引用
收藏
相关论文
共 50 条
  • [21] Formation of Cu2SnS3 thin film by the heat treatment of electrodeposited SnS-Cu layers
    Mathews, N. R.
    Tamy Benitez, J.
    Paraguay-Delgado, F.
    Pal, M.
    Huerta, L.
    JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS, 2013, 24 (10) : 4060 - 4067
  • [22] Fabrication of Cu2SnS3 thin films by ethanol-ammonium solution process by doctor-blade technique
    Yaguang Wang
    Jianmin Li
    Cong Xue
    Yan Zhang
    Guoshun Jiang
    Weifeng Liu
    Changfei Zhu
    Electronic Materials Letters, 2017, 13 : 478 - 482
  • [23] Effect of drying temperature on the structural and optical characteristics of Cu2SnS3 thin films synthesized by simple spin coating technique
    S. Rabaoui
    H. Dahman
    S. Dekhil
    K. Omri
    A. Alyamani
    L. El Mir
    Journal of Materials Science: Materials in Electronics, 2015, 26 : 8588 - 8594
  • [24] Introduction of Na into Cu2SnS3 thin film for improvement of its photovoltaic performances
    Chantana, Jakapan
    Suzuki, Koichi
    Minemoto, Takashi
    SOLAR ENERGY MATERIALS AND SOLAR CELLS, 2017, 168 : 207 - 213
  • [25] Fabrication of Cu2SnS3 thin films by dual-source fine channel mist CVD
    Kazuya Okamura
    Ren Saito
    Ayaka Kanai
    Kunihiko Tanaka
    Applied Physics A, 2022, 128
  • [26] SnS thin films grown by sulfurization of evaporated Sn layers: Effect of sulfurization temperature and pressure
    Caballero, R.
    Conde, V.
    Leon, M.
    THIN SOLID FILMS, 2016, 612 : 202 - 207
  • [27] Tuning Of Opto-Electronic Properties Of Cu2SnS3 Thin Films Through Variation Of Stoichiometry
    Sunny, Gincy
    Kartha, C. Sudha
    Vijayakumar, K. P.
    SOLID STATE PHYSICS: PROCEEDINGS OF THE 58TH DAE SOLID STATE PHYSICS SYMPOSIUM 2013, PTS A & B, 2014, 1591 : 1750 - 1752
  • [28] Thin film solar cells based on the ternary compound Cu2SnS3
    Berg, Dominik M.
    Djemour, Rabie
    Guetay, Levent
    Zoppi, Guillaume
    Siebentritt, Susanne
    Dale, Phillip J.
    THIN SOLID FILMS, 2012, 520 (19) : 6291 - 6294
  • [29] Growth of Cu2SnS3 thin films by a two-stage process: structural, microstructural and optical properties
    Jayasree, Y.
    Chalapathi, U.
    Raja, V. Sundara
    JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS, 2015, 26 (08) : 5946 - 5951
  • [30] Cu2SnS3 absorber thin films prepared via successive ionic layer adsorption and reaction method
    Kahraman, Suleyman
    Cetinkaya, Samed
    Cakmak, Haci Mustafa
    Cetinkara, Haci Ali
    Guder, Husnu Salih
    INTERNATIONAL JOURNAL OF MATERIALS RESEARCH, 2013, 104 (10) : 1020 - 1027