Effect of Tempering Treatment on Atmospheric Corrosion Behavior of 3Cr13 Martensitic Stainless Steel in Marine Environment

被引:0
|
作者
Yong Lian
Jin Zhang
Pengfei Ji
Zunjun Zhang
Minyu Ma
Chao Zhao
Jinfeng Huang
机构
[1] University of Science and Technology Beijing,Institute for Advanced Materials and Technology
[2] Beijing Key Laboratory of Corrosion,State Key Laboratory for Advanced Metals and Materials
[3] Erosion and Surface Technology,undefined
[4] University of Science and Technology Beijing,undefined
来源
Journal of Materials Engineering and Performance | 2022年 / 31卷
关键词
corrosion product; martensitic stainless steel; marine atmosphere corrosion; temper treatment;
D O I
暂无
中图分类号
学科分类号
摘要
In this study, 3Cr13 martensitic stainless steel was tempered to three typical strength grades, and the corresponding atmospheric corrosion behavior in a coastal zone of Wanning, China, was investigated. Electrochemical measurements were taken, and the morphology, composition, and structure of the rust formed after natural exposure were analyzed. The results indicated that different microstructures were obtained by tempering at different temperatures, which affected the corrosion behavior. The electrochemical impedance spectroscopy (EIS) and potentiodynamic polarization results show that the 280°C tempered condition was prone to form a better protective passive film compared to the other two higher-temperature tempered conditions. The corrosion rate of 3Cr13 steel tempered at a low temperature of 280°C was markedly lower than that at higher temperatures of 540 and 600°C. The corrosion weight loss of specimens tempered at 540°C and 600°C was over 8 times higher than that of the specimens tempered at 280°C after two years of natural exposure. The thickness of the rust layer formed on the 540- and 600°C-tempered specimens exceeded 40 μm, which was approximately 5 times that of on the 280°C-tempered specimens. The corrosion products formed on tempered 3Cr13 steel were found to vary with the temper conditions. The corrosion products formed on tempered 3Cr13 martensitic stainless steel also varied with the tempering temperature. A rust layer mainly composed of γ-FeOOH and β-FeOOH was formed on 280°C-tempered 3Cr13 steel specimens, while α-FeOOH and Fe3O4 were formed on 540- and 600°C-tempered 3Cr13 steel specimens in addition to γ-FeOOH and β-FeOOH. Distinct pitting corrosion occurred on specimens of all three strength grades specimens during natural exposure. Formation of Cr-rich carbides during high-temperature tempering increased corrosion pit initiation.
引用
收藏
页码:4963 / 4973
页数:10
相关论文
共 50 条
  • [31] Influence of citric acid passivation treatment on the marine atmospheric corrosion resistance of L80-13Cr stainless steel
    Zhang, Yiheng
    Sun, Jianbo
    Lei, Hongwei
    Jiao, Fengcheng
    Niu, Weiqian
    Xu, Xuexu
    Lin, Xueqiang
    DISCOVER APPLIED SCIENCES, 2025, 7 (04)
  • [32] Corrosion-Electrochemical behavior of 13% chromium (Cr) martensitic stainless steel in hydrochloric acid (HCl) solutions
    Chermat-Aourasse, N.
    Kesri, R.
    PROTECTION OF METALS, 2007, 43 (04): : 344 - 352
  • [33] Corrosion-Electrochemical behavior of 13% chromium (Cr) martensitic stainless steel in hydrochloric acid (HCl) solutions
    N. Chermat-Aourasse
    R. Kesri
    Protection of Metals, 2007, 43 : 344 - 352
  • [34] Corrosion behavior and mechanism of Cr and Cu alloy weathering steel in simulated marine atmospheric environment
    Yin, Chenghui
    Zhang, Xin
    Wang, Shuliu
    Cheng, Junhang
    Zhang, Hao
    Yu, Qiang
    Xiao, Kui
    JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T, 2025, 35 : 3098 - 3106
  • [35] Influence of tempering treatments on mechanical properties and hydrogen embrittlement of 13 wt% Cr martensitic stainless steel
    Bonagani, Sunil Kumar
    Vishwanadh, B.
    Tenneti, Sharma
    Kumar, Naveen N.
    Kain, Vivekanand
    INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING, 2019, 176
  • [36] Effects of temperature on the corrosion behavior of 13Cr martensitic stainless steel during exposure to CO2 and Cl- environment
    Zhang, H
    Zhao, YL
    Jiang, ZD
    MATERIALS LETTERS, 2005, 59 (27) : 3370 - 3374
  • [37] Effect of Heat Treatment on Microstructure and Property of Cr13 Super Martensitic Stainless Steel
    Yu-rong Liu
    Dong Ye
    Qi-long Yong
    Jie Su
    Kun-yu Zhao
    Wen Jiang
    Journal of Iron and Steel Research International, 2011, 18 : 60 - 66
  • [38] Effect of Heat Treatment on Microstructure and Property of Cr13 Super Martensitic Stainless Steel
    Liu Yu-rong
    Ye Dong
    Yong Qi-long
    Su Jie
    Zhao Kun-yu
    Jiang Wen
    JOURNAL OF IRON AND STEEL RESEARCH INTERNATIONAL, 2011, 18 (11) : 60 - 66
  • [39] Effect of Heat Treatment on Microstructure and Property of Cr13 Super Martensitic Stainless Steel
    LIU Yu-rong1
    2. Institute of Structural Materials
    JournalofIronandSteelResearch(International), 2011, 18 (11) : 60 - 66
  • [40] Analysis on surface fine crack of 3Cr13 stainless steel transmission shaft
    Ningbo Tian'anCo., Ltd., Ningbo 315709, China
    Jinshu Rechuli, 2006, 6 (80-82):