Characterization of excimer-laser-annealed polycrystalline silicon films grown by ultrahigh-vacuum chemical vapor deposition

Polycrystalline silicon (poly-Si) films grown by ultrahigh-vacuum chemical vapor deposition (UHVCVD) system and then annealed by excimer laser at room temperature have been investigated for the applications in polycrystalline silicon thin-film transistors (poly-Si TFTs). The results showed that the grain size of the laser-annealed poly-Si film decreased with laser energy density when a lower laser energy density below 157.7 mJ/cm(2) was used. At about the threshold laser energy density (similar to 134.5 mJ/cm(2)), the finest grain structure could be obtained due to the partial melting in the top layer of the film. When the energy density of the excimer laser was larger than the threshold energy density, the large grain growth was initiated. The largest grain structure could be obtained at similar to 184 mJ/cm(2), while its surface roughness was better than that of the nonannealed UHVCVD poly-Si films. The surface roughening was suggested to arise from the specific melt-regrowth process but not the rapid release of hydrogen or capillary wave mechanism derived from laser-annealed amorphous silicon. By use of the laser-annealed UHVCVD poly-Si films as the active layer, the fabricated poly-Si TFT exhibited a field-effect mobility of 138 cm(2)/V s, a subthreshold swing of 0.8 V/dec, a threshold voltage of 3.5 V, and an on/off current ratio of similar to 10(6). (C) 2000 American Institute of Physics. [S0003- 6951(00)03842-0].