Sensorless Control of Induction Motor Drives in the Zero Frequency Speed Range

被引：0
作者：
Zatocil, Heiko [1 ]
机构：
[1] Univ Erlangen Nurnberg, D-91058 Erlangen, Germany
来源：
EPE: 2009 13TH EUROPEAN CONFERENCE ON POWER ELECTRONICS AND APPLICATIONS, VOLS 1-9 | 2009年
关键词：
Adjustable speed drive; sensorless drive; induction motor; modelling; VECTOR CONTROL; MACHINES; OBSERVER; POSITION; FLUX;
D O I：
暂无
中图分类号：
TP301 [理论、方法];
学科分类号：
081202 ;
摘要：
An estimation method for sensorless control employing a test signal based reference model is presented. The method estimates the slip frequency by a comparison of the measured impedance curve while the machine is in operation with the reference model curves. The reference model is measured during DC magnetisation of a cold machine at steady state and constant rotor flux linkage. During normal machine operation the machine temperature and the stator frequency differ from these conditions and thus have a negative influence on quality of the estimation. The impact of these disturbances is investigated and two compensation strategies are presented. Measurements on two different standard induction machines which are not especially designed for sensorless control show that the estimation method allow safe operation at standstill and even at zero frequency.
引用
收藏
页码：274 / 283
页数：10
相关论文
共 22 条
[1]  
CONSOLI A, 2006, IEEE T ENERGY CONVER, V53, P20
[2]   Using multiple saliencies for the estimation of flux, position, and velocity in AC machines [J].
Degner, MW ;
Lorenz, RD .
IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS, 1998, 34 (05) :1097-1104
[3]  
DU T, 1993, P IEE EMD, P179
[4]  
Holtz J., 2005, P PCIM EUR, P80
[5]  
Jotten R., 1983, IEEE T IND APPL, VIA-19, P356
[6]  
KANMACHI T, 1993, IAS 93, PTS 1-3, P408, DOI 10.1109/IAS.1993.298956
[7]  
Kim Y.-C., 1992, IJCNN International Joint Conference on Neural Networks (Cat. No.92CH3114-6), P594, DOI 10.1109/IJCNN.1992.226923
[8]   Regenerating-mode low-speed operation of sensorless induction motor drive with adaptive observer [J].
Kubota, H ;
Sato, I ;
Tamura, Y ;
Matsuse, K ;
Ohta, H ;
Hori, Y .
IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS, 2002, 38 (04) :1081-1086
[9]  
LORENZ RD, 2001, P INT C EL MACH SYST
[10]   VECTOR CONTROL OF INDUCTION-MOTOR WITHOUT SHAFT ENCODER [J].
OHTANI, T ;
TAKADA, N ;
TANAKA, K .
IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS, 1992, 28 (01) :157-164
123