Experimental verification of the mechanisms causing stick-slip motion originating from relative deceleration

被引:12
作者
De Baets, P [1 ]
Degrieck, J
Van De Velde, F
Van Peteghem, AP
机构
[1] Univ Ghent, Dept Mech Prod & Construct, B-9000 Ghent, Belgium
[2] Sidmar Steel Co, Cold Rolling Dept, Zelzate, Belgium
[3] Univ Ghent, Dept Mat Sci, Ghent, Belgium
关键词
stick-slip; deceleration; friction; lubrication;
D O I
10.1016/S0043-1648(00)00428-2
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
In literature, the stick-slip phenomenon is usually explained from an initial stick-phase. The stability conditions with respect to stick-slip (the occurrence or not) are also derived by checking the reoccurrence of a relative standstill (stick-phase) after the slip-phase that has been following an initial stick-phase. However, stick-slip can also arise from an initial situation of pure slip. In this paper, it is experimentally shown that friction induced tangential oscillations during stick-slip can merge into stick-slip during an impressed deceleration, if their amplitude is sufficiently large. Owing to the interaction between friction phenomena and the dynamic behaviour of the mechanical system of which the friction interface is a part, the (negative) friction force-relative speed gradient (dF/d nu(rel)), which gives rise to the tangential oscillations and has to be considered for the study of stick-slip, must be derived from changes of the relative speed with the same time-constant as the mechanical system. It is also experimentally shown that the risk of stick-slip during deceleration is enhanced by an increase of the time-length of deceleration and by an increase of the tangential stiffness of the mechanical system. The correlation of the experimental results with previous theoretical analysis is clarified. As a result, some widely accepted models for the friction as a function of the relative speed have to be put in question. It is also shown that the major problem in determining the gradient dF/d nu(rel) is the inadequateness of the classical friction test rigs. (C) 2000 Elsevier Science S.A. All rights reserved.
引用
收藏
页码:48 / 59
页数:12
相关论文
共 50 条
[21]   Analysis of stick-slip motion by the rate-dependent friction model [J].
Ozaki, S. ;
Hashiguchi, K. ;
Chen, D. H. .
ADVANCES IN FRACTURE AND MATERIALS BEHAVIOR, PTS 1 AND 2, 2008, 33-37 :867-+
[22]   Capillary grip-induced stick-slip motion [J].
An, Sangmin ;
Lee, Manhee ;
Kim, Bongsu ;
Jhe, Wonho .
NANO RESEARCH, 2022, 15 (08) :7384-7391
[23]   Analysis based on microcontact mechanism for the roughness dependent stick-slip motion [J].
Wei, Pal Jen ;
Tsai, Pal Wei ;
Lin, Jen Fin .
WEAR, 2009, 266 (1-2) :310-315
[24]   A topology optimization method and experimental verification of piezoelectric stick-slip actuator with flexure hinge mechanism [J].
Yang, Shitong ;
Li, Yuelong ;
Xia, Xiao ;
Ning, Peng ;
Ruan, Wentao ;
Zheng, Ruifang ;
Lu, Xiaohui .
ARCHIVE OF APPLIED MECHANICS, 2022, 92 (01) :271-285
[25]   Stick-slip Motion Style of Magnetic Field Actuated Microrobots [J].
Zheng, Jianghong ;
Zhan, Ziheng ;
Wei, Fanan .
2019 IEEE 19TH INTERNATIONAL CONFERENCE ON NANOTECHNOLOGY (IEEE-NANO 2019), 2019, :469-472
[26]   A new criterion for occurrence of stick-slip motion in drive mechanism [J].
Ding, WJ ;
Fan, SC ;
Li, MW .
ACTA MECHANICA SINICA, 2000, 16 (03) :273-281
[27]   Parallel Manipulation Based on Stick-Slip Motion of Vibrating Platform [J].
Mayyas, Mohammad .
ROBOTICS, 2020, 9 (04) :1-17
[28]   The relation between friction force and relative speed during the slip-phase of a stick-slip cycle [J].
Van de Velde, F ;
De Baets, P .
WEAR, 1998, 219 (02) :220-226
[29]   Passive normal force control to quench stick-slip motion [J].
Popp, K ;
Rudolph, M ;
Lindner, M .
PROCEEDINGS OF THE 5TH INTERNATIONAL CONFERENCE ON VIBRATION ENGINEERING, 2002, :509-515
[30]   Dynamic simulation of stick-slip motion of a flexible solar array [J].
Kojima, Yasushi ;
Taniwaki, Shigemune ;
Okami, Yoshiaki .
CONTROL ENGINEERING PRACTICE, 2008, 16 (06) :724-735