Experimental verification of the mechanisms causing stick-slip motion originating from relative deceleration

被引:11
作者
De Baets, P [1 ]
Degrieck, J
Van De Velde, F
Van Peteghem, AP
机构
[1] Univ Ghent, Dept Mech Prod & Construct, B-9000 Ghent, Belgium
[2] Sidmar Steel Co, Cold Rolling Dept, Zelzate, Belgium
[3] Univ Ghent, Dept Mat Sci, Ghent, Belgium
关键词
stick-slip; deceleration; friction; lubrication;
D O I
10.1016/S0043-1648(00)00428-2
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
In literature, the stick-slip phenomenon is usually explained from an initial stick-phase. The stability conditions with respect to stick-slip (the occurrence or not) are also derived by checking the reoccurrence of a relative standstill (stick-phase) after the slip-phase that has been following an initial stick-phase. However, stick-slip can also arise from an initial situation of pure slip. In this paper, it is experimentally shown that friction induced tangential oscillations during stick-slip can merge into stick-slip during an impressed deceleration, if their amplitude is sufficiently large. Owing to the interaction between friction phenomena and the dynamic behaviour of the mechanical system of which the friction interface is a part, the (negative) friction force-relative speed gradient (dF/d nu(rel)), which gives rise to the tangential oscillations and has to be considered for the study of stick-slip, must be derived from changes of the relative speed with the same time-constant as the mechanical system. It is also experimentally shown that the risk of stick-slip during deceleration is enhanced by an increase of the time-length of deceleration and by an increase of the tangential stiffness of the mechanical system. The correlation of the experimental results with previous theoretical analysis is clarified. As a result, some widely accepted models for the friction as a function of the relative speed have to be put in question. It is also shown that the major problem in determining the gradient dF/d nu(rel) is the inadequateness of the classical friction test rigs. (C) 2000 Elsevier Science S.A. All rights reserved.
引用
收藏
页码:48 / 59
页数:12
相关论文
共 50 条
  • [1] Experimental verification of stick-slip motion between two rolling contact surfaces
    Zhang, Nong
    Zhang, Jin
    Wang, Yu
    FRONTIERS OF MANUFACTURING SCIENCE AND MEASURING TECHNOLOGY, PTS 1-3, 2011, 230-232 : 1362 - 1366
  • [2] Stick-Slip Mechanisms at the Nanoscale
    Balzer, Bizan N.
    Kienle, Sandra
    Gallei, Markus
    von Klitzing, Regine
    Rehahn, Matthias
    Hugel, Thorsten
    SOFT MATERIALS, 2014, 12 : S106 - S114
  • [3] STICK-SLIP MOTION IN BOUNDARY LUBRICATION
    GAO, C
    TRIBOLOGY TRANSACTIONS, 1995, 38 (02): : 473 - 477
  • [4] Experimental study of stick-slip behaviour
    Adjemian, F
    Evesque, P
    INTERNATIONAL JOURNAL FOR NUMERICAL AND ANALYTICAL METHODS IN GEOMECHANICS, 2004, 28 (06) : 501 - 530
  • [5] Unitary Stick-Slip Motion in Granular Beds
    Hilton, J. E.
    Cleary, P. W.
    Tordesillas, A.
    POWDERS AND GRAINS 2013, 2013, 1542 : 843 - 846
  • [6] Dynamic analysis of stick-slip motion
    Gao, Chao
    Kuhlmann-Wilsdorf, Doris
    Makel, David D.
    1600, Publ by Elsevier Sequoia SA, Lausanne, Switzerland (173): : 1 - 2
  • [7] Slip process of stick-slip motion in the scratching of a polymer
    Zhang, SL
    Li, JCM
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2003, 344 (1-2): : 182 - 189
  • [8] Excitation of energy harvesters using stick-slip motion
    Helseth, L. E.
    SMART MATERIALS AND STRUCTURES, 2014, 23 (08)
  • [9] Experimental Study on the Stick-slip Motion of Even Resin and Steel Contacts
    Hou, Zhi-chao
    Liao, Tao
    Wang, Xiang-wu
    Yano, Akihiko
    Akiyama, Yo
    DYNAMICS FOR SUSTAINABLE ENGINEERING, 2011, VOL 3, 2011, : 1456 - 1461
  • [10] Vibration control to avoid stick-slip motion
    Popp, K
    Rudolph, M
    JOURNAL OF VIBRATION AND CONTROL, 2004, 10 (11) : 1585 - 1600