Further heating of medium temperature carbonization coke

被引:0
|
作者
Uebo, K [1 ]
机构
[1] Sumitomo Met Ind Ltd, Corp Res & Dev Labs, Ibaraki 3140255, Japan
来源
TETSU TO HAGANE-JOURNAL OF THE IRON AND STEEL INSTITUTE OF JAPAN | 2004年 / 90卷 / 09期
关键词
cokemaking; medium temperature carbonization; further heating; coke strength; reaction rate;
D O I
暂无
中图分类号
TF [冶金工业];
学科分类号
0806 ;
摘要
Medium temperature carbonization is one of the technologies to increase productivity of a coke oven. However, strength of lower temperature coke is lower than that of high temperature coke. Then technology covering the decrease of coke strength will be necessary for accompanying the medium temperature carbonization. Heating medium temperature coke further to the high temperature carbonization level after pushed off the oven is one of the methods to modify coke quality. Medium temperature coke was made in a test coke oven and then heated further in a vessel by an electric heater passing model heating gas. The effect of heating conditions and of reactions with reactive gas on coke strength was investigated. It took coke less than one hour to be fully modified at the heating temperature. Carbonized coke below 750degreesC in a coke oven at oven center did not sufficiently recover its strength even in the non-reactive gas. Coke strength decreased in proportion to the weight loss by the reaction with carbon dioxide or steam similarly. However, coke strength slightly decreased in a reaction with oxygen. Change in gas composition along with flow was measured in a coke bed of more than 1.0 m. From the behavior of reactions between coke and reactive gas, their reaction rates were analyzed. Following these results, further heating situation in coke dry quencher (CDQ) by air injection was simulated and it is confirmed that medium temperature coke can be modified in its strength to that of high temperature coke in spite of the weakening of the coke strength by the reaction loss.
引用
收藏
页码:96 / 102
页数:7
相关论文
共 50 条
  • [1] PRODUCTION OF COKE FOR BLAST-FURNACE BY MEDIUM TEMPERATURE CARBONIZATION PROCESS
    IWAKIRI, H
    KAMIJO, T
    KITAMURA, M
    INABA, S
    REVUE DE METALLURGIE-CAHIERS D INFORMATIONS TECHNIQUES, 1992, 89 (03): : 233 - 240
  • [2] Local heating of pyrolyzed polymer heaters for further carbonization at higher temperature
    Naka, K
    Konishi, S
    MEMS 2006: 19TH IEEE INTERNATIONAL CONFERENCE ON MICRO ELECTRO MECHANICAL SYSTEMS, TECHNICAL DIGEST, 2006, : 278 - 281
  • [3] Coke yields by low and high temperature carbonization
    Morrell, JC
    Egloff, G
    INDUSTRIAL AND ENGINEERING CHEMISTRY, 1925, 17 : 764 - 764
  • [4] Coke yields by low and high temperature carbonization
    Sperr, FW
    INDUSTRIAL AND ENGINEERING CHEMISTRY, 1925, 17 : 763 - 764
  • [5] ELASTICITY MODULUS OF COKE AS DEPENDENT ON CARBONIZATION TEMPERATURE
    BARUZDINA, RS
    TAITS, EM
    ESIPOVA, LN
    DOKLADY AKADEMII NAUK SSSR, 1964, 156 (04): : 935 - &
  • [6] Heating patterns during carbonization of formed mixtures of coke and pitch
    Fukai, J
    Orita, H
    Yu, XS
    Isokawa, I
    Miyatake, O
    FUEL, 1996, 75 (07) : 809 - 815
  • [7] ESTIMATION OF COKE POROSITY VARIATION WITH TEMPERATURE DURING CARBONIZATION
    MIURA, T
    FUKAI, J
    MATSUBAYASHI, H
    OHTANI, S
    TETSU TO HAGANE-JOURNAL OF THE IRON AND STEEL INSTITUTE OF JAPAN, 1985, 71 (16): : 1872 - 1879
  • [8] Local Self-Heating of Pyrolyzed Polymer Microstructure for Further Carbonization at Higher Temperature on Silicon Chip
    Naka, Keisuke
    Okamoto, Kanji
    Konishi, Satoshi
    JAPANESE JOURNAL OF APPLIED PHYSICS, 2008, 47 (12) : 8982 - 8985
  • [9] Effects of co-carbonization of medium and low temperature refined pitch and high temperature refined pitch on the structure and properties of needle coke
    Xu, Xian
    Cui, Louwei
    Shi, Junhe
    Liu, Jiaojiao
    Zhu, Yonghong
    Tian, Yafei
    Ma, Mingming
    Liu, Tao
    Zheng, Huaan
    Li, Dong
    JOURNAL OF ANALYTICAL AND APPLIED PYROLYSIS, 2023, 169
  • [10] CARBONIZATION AND COKE CHARACTERIZATION
    TILLMANNS, H
    ACS SYMPOSIUM SERIES, 1986, 303 : 215 - 233