Upgrading of LCO by partial hydrogenation of aromatics and ring opening of naphthenes over bi-functional catalysts

Available options to upgrade LCO to diesel fuel are: i) aromatic saturation (ASAT) ii) mild hydrocracking and iii) aromatic saturation followed by selective ring opening (SRO) of naphthenic structures. Although the above mentioned routes lead to significant product quality enhancement, they suffer from several disadvantages. Hydrocracking leads to significant yields in gasoline-range products. ASAT is characterized by a relatively high consumption of hydrogen with only limited improvement of product quality in terms of density and cetane properties, ASAT + SRO route leads to higher improvements of product quality but it requires a very high hydrogen consumption which strongly affects the economics of the process. An alternative upgrading route consists in partial polyaromatic compound saturation and selective opening of both naphthenic and benzo-naphthenic structures to produce less condensed naphthenic structures and alkyl-benzenes respectively. In this case the hydrogen needed to improve product quality at the same level, of cetane properties and density, is lower in comparison with ASAT. This paper reports the results obtained during a research program aimed at upgrading LCO via selective ring opening. The hydroconversion of a low sulfur hydrotreated LCO has been studied over iridium and platinum loaded on different supports. The results of this study indicate that the properties of products heavily depend on the characteristics of the support and the metal used. The data obtained with the Ir/amorphous silica-alumina (MSA) show the possibility to get a clear increase of CM and decrease of density in comparison with the mere aromatic saturation. The practical consequence of this result is the possibility of producing products with CN and density similar to products obtained by complete dearomatization but still containing a significant percentage of aromatic structures so allowing a consistent saving of hydrogen. (C) 2010 Elsevier B.V. All rights reserved.