Factors influencing the extent and development of the oxic zone in sediments

Dissolved oxygen concentrations in river-sediment porewaters are reported and modelled using a zero-order reaction rate and the Monod equation. After mixing the sediments and allowing settling, the dissolved oxygen profile in the bed-sediment was expected to reach a steady-state rapidly (< 1 h). However changes in the vertical profile of oxygen over a period of 38 days revealed that the penetration of oxygen increased and the dissolved oxygen flux at the interface decreased with time, probably as the oxidation kinetics of organic matter and redox reactions in the sediment changed. Experiments with three contrasting silt and sand dominated sediments ( organic matter content between 0.9 and 18%) at two water velocities (ca 10 and 20 cm s(-1)) showed that the dissolved oxygen profiles were independent of velocity for each of the sediments. The most important controls on the reaction rate were the organic matter content and specific surface area of the sediment. A viscous diffuse-boundary-layer above the sediment was only detected in the experiments with the silt sediment where the sediment oxygen demand was relatively high. In the coarser sediments, the absence of a diffuse layer indicated that slow oxidation processes in the sediment controlled the dissolved oxygen flux at the interface. The problem of determining a surface reference in coarse sediment is highlighted. The results are discussed with reference to other studies including those concerned with estuarine and marine sediments.