3D Printed Anisotropic Dielectric Polarizer for 38 GHz Low Profile Horn Antenna Array

被引：0

作者：

Castro, Nelson ^{[1
]}

Pizarro, Francisco ^{[2
]}

Rajo-Iglesias, Eva ^{[1
]}

机构：

[1] Univ Carlos III Madrid, Dept Signal Theory & Comm, Leganes, Spain

[2] Pont Univ Catolica Valparaiso, Escuela Ingn Elect, Valparaiso, Chile

来源：

2022 INTERNATIONAL SYMPOSIUM ON ANTENNAS AND PROPAGATION (ISAP) | 2022年

关键词：

anisotropic materials; polarizer; 3D-printing;

D O I：

10.1109/ISAP53582.2022.9998625

中图分类号：

TM [电工技术]; TN [电子技术、通信技术];

学科分类号：

0808 ; 0809 ;

摘要：

The following article presents the design of a 3D-printed anisotropic material used as a circular polarizer for a low- profile horn antenna array at 38 GHz. The proposed design is manufactured and measured. Measurement results show that the use of low-loss filaments is suitable for this type of designs at mm-wave frequencies, being a cost-effective solution.

引用

页码：71 / 72

页数：2

共 8 条

[1]

[Anonymous], PREMIX PREPERM WEBSI

[2]

[Anonymous], EC REFORM INTERNATIO, V5, P12

[3] 3D printed anisotropic dielectric composite with meta-material features [J].

Isakov, D. V. ;

Lei, Q. ;

Castles, F. ;

Stevens, C. J. ;

Grovenor, C. R. M. ;

Grant, P. S. .

MATERIALS & DESIGN, 2016, 93 :423-430

[4]

Oliner A., 1957, IRE Trans. Antennas Propag., V5, P4

[5]

Orfanidis S. J., 2016, Electromagnetic waves and antennas

[6] Planar Dual-Mode Horn Array With Corporate-Feed Network in Inverted Microstrip Gap Waveguide [J].

Pucci, Elena ;

Rajo-Iglesias, Eva ;

Vazquez-Roy, Jose-Luis ;

Kildal, Per-Simon .

IEEE TRANSACTIONS ON ANTENNAS AND PROPAGATION, 2014, 62 (07) :3534-3542

[7]

Sihvola A., 2007, Metamaterials, V1, P2, DOI 10.1016/j.metmat.2007.02.003

[8] 3D-printed λ/4 phase plate for broadband microwave applications [J].

Wu, Yingwei ;

Grant, Patrick S. ;

Isakov, Dmitry .

OPTICS EXPRESS, 2018, 26 (22) :29068-29073

← 1 →