Investigation of in-tube cooling of carbon dioxide at supercritical pressure by means of direct numerical simulation

被引:49
作者
Pandey, Sandeep [1 ]
Chu, Xu [1 ,2 ]
Laurien, Eckart [1 ]
机构
[1] Univ Stuttgart, Inst Nucl Technol & Energy Syst IKE, D-70569 Stuttgart, Germany
[2] Univ Stuttgart, Inst Aerosp Thermodynam ITLR, D-70569 Stuttgart, Germany
关键词
Direct numerical simulation; Supercritical carbon dioxide; Turbulent flow; Heat transfer; CONVECTIVE HEAT-TRANSFER; TURBULENT PIPE-FLOW; LOW-REYNOLDS-NUMBER; VERTICAL TUBE; MODELS; CO2; PREDICTION; FLUIDS; CHANNELS; LAYER;
D O I
10.1016/j.ijheatmasstransfer.2017.06.089
中图分类号
O414.1 [热力学];
学科分类号
摘要
To understand the cooling heat transfer behavior of carbon dioxide at supercritical pressure, direct numerical simulations of the flow and heat transfer in circular tubes have been performed at a pressure of 8 MPa, an inlet temperature of 342.05 K and a moderate inlet Reynolds number of 5400. The tube diameter was 2 mm, which is in the range of the hydraulic diameter of a compact heat exchanger. Both forced (gravity neglected) and mixed convection with upward or downward direction of the flow were simulated while the pipe is in vertical orientation. As result of thermal contraction, flow deceleration was observed primarily in the vicinity of the wall, which is opposite to the acceleration observed with wall heating. It is found that combined effects of deceleration and buoyancy in the upward flow enhance the heat transfer while the heat transfer in the downward flow is deteriorated. Further investigations have educed that in downward flow, when the direction of buoyancy force and flow are the same, all turbulent quantities diminish significantly in the axial direction, which is the reason for heat transfer deterioration. Quadrant and octant analyses are presented here to understand the effects of sweep and ejection events on turbulence. Finally, the anisotropy of the Reynolds stress tensor indicates that turbulence is modulated especially in the near-wall region in both upward and downward flow. (C) 2017 Elsevier Ltd. All rights reserved.
引用
收藏
页码:944 / 957
页数:14
相关论文
共 38 条
[1]   REVIEW OF SUPERCRITICAL CO2 POWER CYCLE TECHNOLOGY AND CURRENT STATUS OF RESEARCH AND DEVELOPMENT [J].
Ahn, Yoonhan ;
Bae, Seong Jun ;
Kim, Minseok ;
Cho, Seong Kuk ;
Baik, Seungjoon ;
Lee, Jeong Ik ;
Cha, Jae Eun .
NUCLEAR ENGINEERING AND TECHNOLOGY, 2015, 47 (06) :647-661
[2]   Direct numerical simulation of turbulent supercritical flows with heat transfer [J].
Bae, JH ;
Yoo, JY ;
Choi, H .
PHYSICS OF FLUIDS, 2005, 17 (10)
[3]   Direct numerical simulation of heated CO2 flows at supercritical pressure in a vertical annulus at Re=8900 [J].
Bae, Joong Hun ;
Yoo, Jung Yul ;
McEligot, Donald M. .
PHYSICS OF FLUIDS, 2008, 20 (05)
[4]   Assessment of low-Reynolds number k-ε turbulence models against highly buoyant [J].
Bae, Yoon-Yeong ;
Kim, Eung-Seon ;
Kim, Minhwan .
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2017, 108 :529-536
[5]   Forced and mixed convection heat transfer to supercritical CO2 vertically flowing in a uniformly-heated circular tube [J].
Bae, Yoon-Yeong ;
Kim, Hwan-Yeol ;
Kang, Deog-Ji .
EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2010, 34 (08) :1295-1308
[6]   Convective heat transfer to CO2 at a supercritical pressure flowing vertically upward in tubes and an annular channel [J].
Bae, Yoon-Yeong ;
Kim, Hwan-Yeol .
EXPERIMENTAL THERMAL AND FLUID SCIENCE, 2009, 33 (02) :329-339
[7]   Laminar convective heat transfer of supercritical CO2 in horizontal miniature circular and triangular tubes [J].
Cao, X. L. ;
Rao, Z. H. ;
Liao, S. M. .
APPLIED THERMAL ENGINEERING, 2011, 31 (14-15) :2374-2384
[8]   Analysis of supercritical CO2 cooling in macro- and micro-channels [J].
Cheng, Lixin ;
Ribatski, Gherhardt ;
Thome, John R. .
INTERNATIONAL JOURNAL OF REFRIGERATION-REVUE INTERNATIONALE DU FROID, 2008, 31 (08) :1301-1316
[9]  
Chu X., 2016, J NUCL EN GRADIAT SC
[10]   Direct numerical simulation of strongly heated air flow in a vertical pipe [J].
Chu, Xu ;
Laurien, Eckart ;
McEligot, Donald M. .
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2016, 101 :1163-1176