Plastic instabilities and dislocation densities during plastic deformation in Al-Mg alloys

被引:74
作者
Horvath, Gyozo [1 ]
Chinh, Nguyen Q. [1 ]
Gubicza, Jeno [1 ]
Lendvai, Janos [1 ]
机构
[1] Eotvos Lorand Univ, Dept Mat Phys, H-1117 Budapest, Hungary
来源
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING | 2007年 / 445卷
基金
匈牙利科学研究基金会;
关键词
Al-Mg alloys; plastic instabilities; dislocation densities;
D O I
10.1016/j.msea.2006.09.019
中图分类号
TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
Plastic deformation of Al-Mg alloys were investigated by analyzing the stress-strain curves obtained in uniaxial compression tests at constant loading rate. Experimental results have shown the well-known phenomenon of plastic instabilities - the Portevin-Le Chatelier effect - in these solid solution alloys. Using the characteristics of plastic instabilities - the local stress increment, Delta sigma, - dislocation densities were calculated and compared with those determined by considering the global strain hardening. The influence of the increasing Mg concentration on the multiplication and the annihilation of dislocations, as well as on the development of the mobile and immobile dislocation densities was also analyzed. (c) 2006 Elsevier B.V. All rights reserved.
引用
收藏
页码:186 / 192
页数:7
相关论文
共 38 条
  • [1] On the characteristics of Portevin-Le Chatelier bands in aluminum alloy 5182 under stress-controlled and strain-controlled tensile testing
    Abbadi, M
    Hähner, P
    Zeghloul, A
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2002, 337 (1-2): : 194 - 201
  • [2] The onset of Portevin-LeChatelier instabilities in tensile testing
    Balík, J
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2001, 316 (1-2): : 102 - 108
  • [3] Occurrence of plastic instabilities in dynamic microhardness testing
    Berces, G
    Chinh, NQ
    Juhasz, A
    Lendvai, J
    [J]. JOURNAL OF MATERIALS RESEARCH, 1998, 13 (06) : 1411 - 1413
  • [4] Kinematic analysis of plastic instabilities occurring in microhardness tests
    Berces, G
    Chinh, NQ
    Juhasz, A
    Lendvai, J
    [J]. ACTA MATERIALIA, 1998, 46 (06) : 2029 - 2037
  • [5] Serrated yielding due to Portevin-Le Chatelier effect in commercial Al-Mg alloys
    Chihab, K
    Ait-Amokhtar, H
    Bouabdellah, K
    [J]. ANNALES DE CHIMIE-SCIENCE DES MATERIAUX, 2002, 27 (01): : 69 - 75
  • [6] Kinematic and dynamic characterization of plastic instabilities occurring in nano- and microindentation tests
    Chinh, NQ
    Horváth, G
    Kovács, Z
    Juhász, A
    Bérces, G
    Lendvai, J
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2005, 409 (1-2): : 100 - 107
  • [7] A new constitutive relationship for the homogeneous deformation of metals over a wide range of strain
    Chinh, NQ
    Horváth, G
    Horita, Z
    Langdon, TG
    [J]. ACTA MATERIALIA, 2004, 52 (12) : 3555 - 3563
  • [8] Critical concentration of Mg addition for plastic instabilities in Al-Mg alloys
    Chinh, NQ
    Csikor, F
    Kovács, Z
    Lendvai, J
    [J]. JOURNAL OF MATERIALS RESEARCH, 2000, 15 (05) : 1037 - 1040
  • [9] Depth-sensing indentation tests in studying plastic instabilities
    Chinh, NQ
    Gubicza, J
    Kovács, Z
    Lendvai, J
    [J]. JOURNAL OF MATERIALS RESEARCH, 2004, 19 (01) : 31 - 45
  • [10] Characterization of plastic instability steps occurring in depth-sensing indentation tests
    Chinh, NQ
    Horváth, G
    Kovács, Z
    Lendvai, J
    [J]. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2002, 324 (1-2): : 219 - 224