Removal of Cu(II) from aqueous solution in a fluidized-bed reactor

In this study, a fluidized-bed reactor (FBR) was employed to treat copper-containing wastewater by mean of copper precipitation on the surface of sand grains. The conditions for optimum copper removal efficiency were also investigated. This technology was controlled so as to keep supersaturation low to induce the nucleated precipitation of copper coating on the sand surface in an FBR. The effects of relevant parameters, such as the pH value, the molar ratio of [C-T] to [Cu2+], hydraulic loading and the types of chemical reagents used, were examined. The experimental results indicated that 96% copper removal efficiency could be achieved when the influent copper concentration was 10 mg l(-1). The optimum chemical reagent was Na2CO3; the molar ratio of [C-T]/[Cu2+] was 2, and the optimal hydraulic loading was not be more than 25 m h(-1). In addition, preventing homogeneous nucleation in the FBR was an important operation parameter. Homogeneous nucleation and molecular growth would lead to undesirable microparticle formation in the effluent. A good mixture of carbonate and copper in the presence of sand grains could reduce the level of homogeneous nucleation in the bottom of the reactor. Energy dispersive analysis (EDS) of X-rays provided insight into the copper coating on the sand surface, and element analysis indicated the weight percentages of CuCO3 and Cu(OH)(2) in precipitate. (C) 2004 Elsevier Ltd. All rights reserved.